Boneco U350 User manual

U350
MANUAL
Read and save these instructions
Lisez et enregistrez ces instructions
Lea y guarde estas instrucciones

2
EN Always observe all safety notes (included separately in delivery).
FR Veuillez respecter impérativement l’ensemble des consignes de sécurité
(fournies séparéme nt dans le contenu de la livraison).
ES Tenga en cuenta siempre todas las indicaciones de seguridad (se suministran aparte junto con
el producto).

3

EN Instructions for use 5
FR Instructions d’utilisation 21
ES Instrucciones de uso 37

5
en
INSTRUCTIONS FOR USE

6
en
TABLE OF CONTENTS
Introduction 7
Healthy air is a basic need 7
Availability of accessories 7
Items included 7
Technical data 8
Overview and part names 9
The right location 10
The right location 10
A250 AQUA PRO 10
Indicators on the display 11
Keypad 12
Starting up and switching o 13
Humidity and ultrasonic 15
Save settings 15
“AUTO” comfort mode 15
Controlling humidity 15
Regulating performance 15
Comfort functions 16
Switching the heater on and o 16
Fragrance container 16
Timer functions 17
Setting the OFF timer 17
Setting the ON timer 17
Cleaning and maintenance 18
Care instructions 18
Cleaning and descaling 19
Descaling 19
Removing mineral deposits 20
Clearing the cleaning message 20
On the A250 21
Preparing the A250 21
On water hardness 21
Replacing the A250 21
Replacement 21

7
en
INTRODUCTION
ITEMS INCLUDED
HEALTHY AIR IS A BASIC NEED
There is little to which we react with greater sen-
sitivity than poor air. And yet many people do not
pay enough attention to air quality, which has con-
sequences for health and quality of life. This makes
us all the more pleased that you have chosen a TOP-
BONECO appliance to ensure that the basic need for
healthy room air is satisfied for you and the people
around you.
AVAILABILITY OF ACCESSORIES
You can obtain replacements for worn-out accesso-
ries as well as additional accessories from:
• Your BONECO specialist dealer,
• At www.shop.boneco.us or
• Directly via the “BONECO healthy air” app.
A250 AQUA PRO
Quick Manual
BONECO U350
Safety instructions
A7417 “EZCal”
descaling powder
Water hardness test strips

8
en
TECHNICAL DATA
* During operation with pre-heating
** @120V ~60 Hz
Mains voltage 100 – 120 V ~50/60 Hz
Power consumption <30 W** / <115 W*/**
Humidity output 3.170 gal/day (500 g/h) */**
For rooms up to 730 sq ft (68 m2)
Water capacity 1.32 gallons (5.0 liters)
Dimensions L×W×H 12.1 ×6.5 ×12.7 in. (308 ×165 ×325mm)
Weight (empty) 6 lbs (2.74 kg)
Operation noise level <35 dB(A)
TECHNICAL DATA*

9
en
OVERVIEW AND PART NAMES
1
2
6
5
7
8
3
4
1Cover
2Nozzle
3Flue
4Touch display
5Cleaning brush
6A250
7Fragrance container
8Power supply

10
en
THE RIGHT LOCATION
THE RIGHT LOCATION
The BONECO appliance releases more than half a
liter of water into the air per hour. This makes it im-
portant to set up the appliance in the right location.
Do not place the BONECO appliance directly
on the floor, since the moisture from the mist
can damage floor surfaces such as parquet or deli-
cate carpeting.
Make sure that the appliance stands about one foot
(30 centimeters) away from the closest wall.
Do not direct the mist toward the wall, plants, fur-
niture or other objects in order to prevent water
condensation from damaging them. Maintain a dis-
tance of at least 20 inches (50cm).
A250 AQUA PRO
Please observe the accompanying instructions for
starting the A250 AQUA PRO.

11
en
INDICATORS ON THE DISPLAY
Overview of all indicators on the display
Symbol Meaning
Current or desired humidity 15
Fully automated operation 15
Heater turned on 16
Timer active 17
Value shows the current humidity 15
Value shows the desired humidity 15
Symbol Required action
Refill the water 18
Change the water in the appliance 18
Cleaning required 19

12
en
KEYPAD
Keypad on the appliance
Button Function
Switching unit on and o 14
Regulating output 15
“AUTO” comfort mode 15
Switch heater on/o 16
Access the timer function 17
Change the humidity 15

13
en
STARTING UP AND SWITCHING OFF
654
3
2
1
Screw the A250 to the BONECO appliance. Fill the tank with cold tap water.
Connect the BONECO appliance to the power
outlet.
Rinse the A250 for 2 minutes under cold running
water.
Tap to switch on the BONECO appliance. Direct the mist into the open room.

14
en
9
8
7
Tap again to switch o the BONECO appliance
entirely.
Do not place the BONECO appliance directly on
the floor.
Select the desired output level using the
button.
STARTING UP AND SWITCHING OFF

15
en
HUMIDITY AND ULTRASONIC
SAVE SETTINGS
The BONECO appliance saves the last-used settings
when it is switched o. However, if the appliance is
disconnected from the power supply for a few sec-
onds, it will start in the operating mode.
“AUTO” COMFORT MODE
After the unit is switched on, it is in -Mode.
The desired relative humidity (rH) is preset to
50%. The unit chooses the appropriate output
level Low “L” / Medium “M” / High “H”, in order to
attain the value of 50% rH as quickly as possible.
In -Mode, the rH can be changed at any time
by using button . If the output level is changed by
using button , the -Mode turns o and the
unit is operated manually.
The heater can be switched on or o without the
appliance leaving mode. mode also re-
mains active when setting the timer.
To return to mode, tap the symbol once.
CONTROLLING HUMIDITY
The humidity can be set between 30% and 70%. In
the “Co” setting (for “Continuous”), the ultrasonic
runs regardless of the measured humidity. This
means it does not switch o until the tank is empty
or the appliance is switched o.
1. Tap the symbol. The current humidity indica-
tor starts flashing.
2. While the indicator is flashing, tap the symbol
again until the desired humidity is set.
The value is applied after a few seconds. The indica-
tor stops flashing.
REGULATING PERFORMANCE
1. Tap the symbol multiple times until the de-
sired level appears on the display.
The symbol on the display indicates which of the
three levels (low/medium/high) has been selected:

16
en
COMFORT FUNCTIONS
SWITCHING THE HEATER ON AND OFF
The BONECO appliance is equipped with a heater
that can be turned on and o. It warms the outgo-
ing mist up to approximately 95 °F (35 °C), so that
the room temperature stays at a comfortable level.
It takes a few minutes until the heater reaches its
full output.
1. Tap the symbol once to switch on or o the
heater.
FRAGRANCE CONTAINER
Commercially available scented aromatic substanc-
es for humidifiers can be added to the fragrance
container on the back of the BONECO appliance.
Never add the aromatic substance directly
into the water tank or water base; doing so
will damage the BONECO appliance and void the
warranty!
1. Press down on the fragrance container to unlock
the drawer.
2. Sprinkle the cotton wadding in the drawer with
the fragrance of your choice.

17
en
TIMER FUNCTIONS
The timer function lets you determine how long the
BONECO appliance should run before it switches o
automatically (OFF timer).
Alternatively, you can specify a time for when the
appliance should switch on automatically (ON
timer). For example, you can use this function to
activate the BONECO appliance before you return
home, so that when you get back you have the per-
fect home climate waiting for you.
SETTING THE OFF TIMER
1. Switch on the BONECO appliance.
2. Select the desired settings.
3. Tap the symbol multiple times until the de-
sired run time is displayed.
Now the BONECO appliance will run for the specified
time and then switch o.
4. To deactivate the OFF timer early, switch the
BONECO appliance o and back on as needed.
SETTING THE ON TIMER
1. Switch o the BONECO appliance.
2. Tap the symbol multiple times until the de-
sired standby time is displayed.
The BONECO appliance switches on after the defined
time and operates with the selected settings.
3. To deactivate the ON timer early, switch the
BONECO appliance o and back on as needed.

18
en
CLEANING AND MAINTENANCE
CARE INSTRUCTIONS
With time and use, the performance of the A250
decreases and scale builds up on the inner parts of
the BONECO appliance. Stagnant water can also im-
pair cleanliness and lead to unpleasant odors. This
means regular maintenance and cleaning is neces-
sary to ensure clean and unimpaired operation.
Recommended cleaning and maintenance intervals
vary depending on air and water quality, and oper-
ating time.
Use a soft, damp cloth to clean the exterior.
Always unplug the unit from the power outlet
before cleaning.
Interval Task
Daily Check the water level; add water if necessary
After 1 week without operation Empty and clean the BONECO appliance
Every 2 weeks Clean the water base and water tank
Every 2 –6 months Replacing the A250

19
en
CLEANING AND DESCALING
DESCALING
If stubborn limescale deposits form at the bottom
of the BONECO appliance, the appliance must also
be descaled in addition to the cleaning. For this pro-
cess, use the provided “EZCal” descaling agent. You
can get replacement parts at your BONECO special-
ist dealer or at the online store under www.shop.
boneco.us
1. Disconnect the BONECO appliance from the pow-
er outlet.
The unit must always be unplugged from the
power outlet before draining it. Failure to do
so can result in electric shock and pose the risk of
severe or fatal injury!
2. Empty the water tank.
Tip the long side of the BONECO appliance
towards the sink (with the viewing window
facing down). This prevents water from getting into
the air outlet and damaging the unit.
3. Remove the A250.
4. Mix 1 bag of EZCal with 32 oz. (1 liter) of water
and pour the mixture into the water tank, one
half to the left and right each.
5. Wait 30 minutes to allow the solution to take ef-
fect.
6. Rinse the water tank with tap water. Remove re-
maining lime residue, if any, using a scrub brush.
7. Rinse the inside of the water tank with fresh tap
water.
8. Reinsert the A250.

20
en
REMOVING MINERAL DEPOSITS
Mineral deposits on the membrane can be removed
using the yellow cleaning brush attached to the
cover of the BONECO appliance.
Never clean the membrane using sharp ob-
jects or aggressive cleaning agents; doing so
can damage the BONECO appliance and voids the
warranty!
CLEARING THE CLEANING MESSAGE
After completion of cleaning, delete the message
by pressing the button and holding it for
2seconds.