Bosch FMM-7045 Series User manual

Fire Alarm Systems | FMM-7045 Series Multiplex Addressable Manual Stations
The FMM-7045 Series Multiplex Manual Stations are UL
Listed fire alarm initiating devices that can be connected
along with other multiplex devices on the D7039
Multiplex Expansion Module. The D7024 Addressable
Fire Alarm Control Panel (FACP) supervises the entire
multiplex loop, including the FMM-7045 or FMM-7045-D
manual stations, for troubles, alarms, and ground fault
conditions. Because each manual station occupies only
one address on the multiplex bus, it can be addressed
for any point within the 9 to 255 range allowed by the
multiplex expansion module.
These manual stations are generally installed near
building exits such as stairways and doors, allowing
persons evacuating the building to activate the fire
alarm. They have optional scored acrylic breakrods and
a pull handle that locks in the activated position, to allow
easy identification of alarm activation points.
These manual stations are high-quality units constructed
entirely of non-toxic materials. They have a low profile
and rounded edges to fit most design applications. All
components are painted or have plated surfaces to
inhibit corrosion. Non-corroding screw terminals are
provided for wire connections. They are manufactured
in conformance with the standards set forth in the
Americans with Disabilities Act (ADA).
Functions
Alarm Action
The single-action FMM-7045 has a white pull-down lever
in its center; while the dual-action FMM-7045-D has a
white push lever above the white pull-down lever in its
center. Pulling down the pull-down lever latches it into
place and sends an alarm signal to the control panel over
the multiplex bus. The pull-down lever cannot be reset
unless the correct key is inserted into the manual
station's lock and the unit opened. The latching lever can
then be restored to its normal position.
Certifications and Approvals
Listings and UL UNIU: Boxes, Non-Coded (UL38)
Approvals: CSFM: 7150-1615: 122
Complies with: Americans with Disabilities Act (ADA 4.28.3)
National Fire Protection Association (NFPA 72)
FMM-7045 Series Multiplex Addressable
Manual Stations
▶Easy addressing with rotary switches
▶Low current draw
▶Key-lock reset
▶Replaceable scored acrylic breakrod option
▶Terminal connections
▶ADA compliant
▶UL Listed
www.boschsecurity.com

2 | FMM-7045 Series Multiplex Addressable Manual Stations
Installation/Configuration Notes
Compatibility Information
The FMM-7045 Series Multiplex Manual Stations are
compatible with a D7024 FACP with firmware revision
2.0 or greater with a D7039 Multiplex Expansion Module
Addressing
Addresses are set using three rotary switches. Refer to
the D7024 Installation Manual (P/N: 31499 ) and the
FMM-7045 Series Multiplex Manual Stations (P/
N: F01U001402) for programming information.
Mounting
The FMM-7045 manual stations are for indoor use only.
The FMM-7045 manual stations flush mount on a
standard four-inch square back box with a single-gang
mud ring at least 0.625 in. (1.6 cm) deep. For surface
mounting, use an FMM-100BB-R Surface‑mount Back
Box.
Wiring
The terminal block accepts wiring up to 12 AWG
(2.3 mm) in diameter. Refer to the D7039 Installation
Instructions (P/N: 38685) for multiplex wiring
information.
Parts Included
Quant. Component
1 Manual station
1 FMM-100GR Scored Acrylic Breakrod
1 D102 Key (1358)
1 Literature pack
Technical Specifications
Environmental Considerations
Radio Frequency
Interference (RFI)
Immunity:
No alarm on critical frequencies in the range
from 26 MHz to 950 MHz at field strengths less
than 30 V/m.
Temperature (Operating): +32°F to +120°F (0°C to +49°C)
Mechanical Properties
Dimensions (H x W x D): 4.75 in. x 3.75 in. x 3.25 in.
(12 cm x 9.5 cm x 8.2 cm)
Material: Die cast zinc alloy and steel
Power Requirements
Current Draw (Mux Bus
Average):
Alarm: 0.55 mA
Standby: 0.55 mA
Voltage (Operating): 12 VDC nominal (provided by the MUX bus)
Ordering Information
FMM-7045 Single-Action Manual Station FMM-7045
FMM-7045-D Double-Action Manual Station FMM-7045-D
Hardware Accessories
D102 Replacement Key D102
FMM-100BB-R Surface-mount Back Box (red) FMM-100BB-R
FMM-100GR Scored Acrylic Breakrods FMM-100GR
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
Americas:
Bosch Security Systems
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.us
Asia-Pacific:
Bosch Security Systems Pte Ltd
38C Jalan Pemimpin
Singapore 577180
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
Represented by
© Bosch Security Systems 2006 | Data subject to change without notice
F1930608395 | Cur: en-US, V4, 3 Mar 2006