Bradley S19-220SC User manual

Installation
215-158SC Rev. J; ECN 12-05-033
© 2013 Bradley
Page 1 of 4 3/19/2013
S19-220SC
Wall-Mounted Eyewash with
Dust Cover
Table of Contents
Pre-Installation Information ..............2
Installation Instructions.................. 3
Assembly of Components ...............4
Parts List ............................4
netzerotools.com
netzerotools.com
netzerotools.com
Bradley S19-220SC Emergency Eyewash With Dust Cover

2
S19-220SC Installation
3/19/2013
IMPORTANT
Read this installation manual completely to ensure proper installation, then file it
with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before
discarding any packaging material. If any parts are missing, do not begin installation
until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation is
complete. Test the unit for leaks and adequate water flow. Main water supply to the
eyewash should be “ON” at all times. Provisions shall be made to prevent unauthorized
shutoff.
The ANSI Z358.1 standard requires an uninterrupted supply of flushing fluid. Bradley
plumbed emergency fixtures require a minimum of 30 PSI (0.21 MPa) flowing pressure.
Flushing fluid should be tepid per ANSI Z358.1.
The inspection and testing results of this equipment should be recorded weekly to verify
proper operation. This equipment should be inspected annually to ensure compliance
with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be
trained regarding the placement and proper operation of emergency equipment per ANSI
Z358.1.
Product warranties and parts information may also be found under ”Products”.
Installation
THIS
SIDE
UP
Packing List

P
.O.Box309, Menomonee Falls, WI 53051
R
TESTTHISUNIT EACHWEEK
Test-operatevalve(s) each week and sign below.
Reportanymalfunctions immediately.
Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt
durchUnterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT1ST WÖCHENTLICH ZU PRÜFEN.
ESSAIHEBDOMADAIRE
Testle fonctionnement des valves chaque semaine et
signeen bas. S'il y à quelquechose qui ne va pas fait
unrapport immédiatement.
P.O.BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL:1-800-BRADLEY FAX:[phone])
http://www.bradleycorp.com
114-051
netzerotools.com
netzerotools.com

3
Installation S19-220SC
3/19/2013
Installation
Supplies Required:
bracket
Step 1: Install wall bracket
NOTE: The top of the eyewash heads should be
33"–45"(838mm–1143mm) from the floor.
Step 2: Assemble components
Step 3: Connect water supply
81⁄8"
(206mm)
21½" (546mm)
36"
(914mm)
suggested
height to
floor
Ø 10¾" (273mm)
4"
(102mm)
13½"
(343mm)
4½"
(114mm)
8¾"
(222mm)
17¼"
(438mm)
5¼"
(133mm)
7¼"
(184mm)
30½"
(775mm)
suggested
height to
floor
netzerotools.com
netzerotools.com

4
S19-220SC Installation
3/19/2013
Assembly of Components and Parts List - S19-220SC
P.O. Box 309, Menomonee Falls,WI 53051
R
TESTTHIS UNIT EACH WEEK
Test-operatevalve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt
durchUnterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAIHEBDOMADAIRE
Testle fonctionnement des valves chaque semaine et
signe en bas.S'il y à quelque chose qui ne va pas fait
un rapport immédiatement.
P.O. BOX 309,MENOMONEE FALLS, WI 53052-0309 USA
TEL:1-800-BRADLEY FAX:[phone])
http://www.bradleycorp.com
114-051
9
8
5
1.1
1.2
1.3
1.4
1.5
1.6
1.7
1.8 1.9
1.10
1.11
23
4
4.1
1.12
1.13
6
1.14
1.14
10
9
NOTE: Items 1.1-1.13 come preassembled as Item 1.
Prepack S45-1787 includes Items 1.4, 1.6, 1.7, 1.8
Prepack S30-112 includes Items 4, 5, 9, 10
1.2 124-028 1 Gasket
1.3 140-645 1 Wall Bracket
1.4 124-024 1 Gasket
1.5 S90-009 1 Supply Stem
1.6 173-009 1 Cup Strainer
1.7 S21-072 1 Supply Stem
1.8 113-1159 1 Spacer, Drain
1.12 269-447 1 Bumper
1.13 161-025 1 Hex Nut
4.1 110-248 1 Nut 316 Stainless Steel
5 S08-056 1 Handle Assembly
10 153-372R 1 Adapter
Item Part No. Qty. Description Item Part No. Qty. Description
Supply Inlet
Drain Outlet closed.
For proper handle and ball valve kits,
refer to instruction sheet 215-1774.
netzerotools.com
netzerotools.com