Bradley Terreon MG Series Product information sheet

215-1442; EN 02-800
Page 1 of 6
P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY FAX [phone]
http://www.bradleycorp.com
Installation
Instructions
MG-WR
Terreon® Waste
Receptacle - MG-Series
Table of Contents
Pre-Installation Information ................2
MG-WR Components .....................2
MG-WR Layout Options ...................3
MG-WR Installation .....................4-5
Cleaning and Maintenance ..................6
IMPORTANT
Read this entire installation manual to
ensure proper installation.
Wall anchors used must have a minimum
pull-out rating of 1,000 lbs.
File these instructions with the owner or
maintenance department.

2Bradley Corporation • 215-1442; EN 02-800
Terreon® Waste Receptacle - MG-Series
MG-WR Installation Instructions
Pre-Installation Information
Waste Receptacle and Cover Material
The wall-mounted MG-WR receptacle is constructed of stainless steel. The MG-WR cover is
constructed of Terreon®, a densified solid surface material composed of polyester resin and acrylic.
Terreon®is resistant to chemicals, stains, burns and impact. Surface damage can be easily repaired
with everyday cleaners or fine grit abrasives.
Supplies Required:
• (2) 1/4"-20 wall anchors and screws
• OPTIONAL: (2) additional 1/4" wall
anchors for optional side wall mounting
• Caulk
Check Contents
Separate all parts from the packaging and
check each part with the drawing at right.
Make sure all parts are accounted for before
discarding any packaging material. If any
parts are missing, do not attempt to install
your Terreon®Waste Receptacle until you
obtain the missing parts.
MG-WR COVER (Part
number varies with color.
Please contact your local
Bradley representative).
MOUNTING
HARDWARE
PREPACK
(S45-1796)
(qty. 2)
VINYL LINER
(optional, not
shown)
(P11-006)
MG-WR
ASSEMBLY
(S39-563)
Terreon®Waste Receptacle Warranty
Bradley Corporation warrants to commercial and institutional purchasers only each unit free from defects in material and
workmanship under normal use and service upon the following terms and conditions.
1. This warranty is limited to replacing or repairing, at our option, transportation charges prepaid by the purchaser, any
Bradley unit or part thereof which our inspection shall show to have been defective within the limitations of this
warranty.
2. The period during which Terreon®Waste Receptacle Cover components are warranted is as follows:
• Terreon®cover warranted for five (5) years.
• all other components warranted for one (1) year.
3. This warranty does not cover installation or any other labor charges and does not apply to any units which have been
damaged by accident, abuse, improper installation or improper maintenance.
4. The replacement or repair of defective units as stated in this warranty shall constitute the sole remedy of the purchaser
and the sole liability of Bradley Corporation under this warranty. Bradley Corporation shall not otherwise be liable
under any indirect damages caused by defects in the repair or replacement thereof.
5. This warranty extends only to commercial and institutional purchaser and does not extend to any others, including
consumer customers of commercial institutional purchasers.
6. This warranty is in lieu of all other warranties, expressed or implied, including any implied warranty of merchants
ability or fitness for a particular purpose or otherwise.
TEMPLATE
(186-1384)

3Bradley Corporation • 215-1442; EN 02-800
Terreon® Waste Receptacle - MG-Series
Installation Instructions MG-WR
MG-WR Layout Options
19"
(483mm)
19"
(483mm)
19"
(483mm)
BTWN - waste receptacle mounted between two lavatory systems
AL - waste receptacle mounted on left side of alcove
AR - waste receptacle mounted on right side of alcove

4Bradley Corporation • 215-1442; EN 02-800
Terreon® Waste Receptacle - MG-Series
MG-WR Installation Instructions
Installation Instructions
Step 1: Install MG-WR cover to Express® Lavatory System
NOTE: For best result, mount receptacle and cover at exact locations given in the instructions.
1. Install two 1/4"-20 wall anchors (supplied by installer) at the waste can anchor locations shown
in Figure 1.
NOTE: The MG-WR cover is 20" (508 mm) wide at the back wall.
2. Position the MG-WR cover between the Express® Lavatory Systems (or wall) and check to be
sure there is no interference. If the MG-WR cover needs trimming, use template (p/n 186-1384)
as a guide to trim the contoured edge of the cover (see Figure 2 on page 5).
NOTE: The template (186-1384) can be used for left-hand or right-hand bowl installations.
3. Using the template (p/n 186-1384), locate and mark two clearance holes on the Express®
Lavatory System side apron (see Figure 2 on page 5). Drill two clearance holes for 1/4" bolts
through the apron at the hole locations marked.
• If one side of the MG-WR cover is to be attached to a side wall, install two 1/4" wall anchors
(supplied by installer) to the wall at the locations shown in Figure 1.
4. Attach the brackets (p/n 140-787) to the Express® side apron using the (1/4-20 hex bolt (p/n
160-231), washers (p/n 142-002AV) and nuts (p/n 161-026) provided (see Figure 4 on page 5).
• If a bracket is to be attached to a side wall, install two 1/4" wall anchors (supplied by installer)
and secure the bracket to the wall with fasteners (supplied by installer) at the locations shown
in Figure 1.
5. Position the MG-WR cover onto the brackets and secure the cover in place with the #10 screws
(p/n P18-054) and washers (p/n 142-002AZ) provided.
• Screws attach to the underside of the MG-WR cover at four places (see Figure 3 on page 5).
• The top of the MG-WR cover should be positioned 1/2" below the top deck of the Express®
Lavatory System. The MG-WR cover should be flush against the bottom aprons of the
Express® Lavatory System.
6. Caulk the seams as needed.
Figure 1 TWO 1/4" ANCHORS
(SUPPLIED BY INSTALLER)
14" (356mm)
7"
(178mm)
29.12"
(740mm) WASTE
CAN
FLOOR FLOOR
COVER
CENTERLINE OF
RECEPTACLE
3.5" REF.
(89mm)
25" REF.
(635mm)
BACK WALL
TWO 1/4" ANCHORS
(SUPPLIED BY
INSTALLER)
2"
(51mm)
5.85"
(149mm)
31.62"
(803mm)
OPTIONAL WALL MOUNTING

5Bradley Corporation • 215-1442; EN 02-800
Terreon® Waste Receptacle - MG-Series
Installation Instructions MG-WR
Figure 2
Figure 3
Step 2: Install waste receptacle
NOTE: Optional vinyl liner comes with hook-and-loop
fasteners. Alcohol swabs are provided for cleaning the inside
of the waste receptacle prior to attaching the fasteners.
1. OPTIONAL VINYL LINER: Insert liner into the waste
can. Clean the inside of the waste receptacle with alcohol
at the locations where the hook-and-loop fasteners will
be attached.
2. Insert two 1/4" pan head fasteners into the wall
anchors leaving approximately 1/16" to 1/8" of the
threads exposed.
3. Using the two key holes on the back of the receptacle,
hang the waste receptacle onto the fasteners (see
Figure 5). Figure 5
TEMPLATE
(186-1384)
(Use as a guide
for locating
clearance
holes)
Drill
clearance
holes for
1/4" bolts
EXPRESS® MG-SERIES SIDE APRON
MG-WR
COVER
TEMPLATE (186-1384)
(Use as a guide for in-field adjustments)
BOLT, 1/4-20 HEX
(160-231)
LOCKWASHER, 1/4
(142-002X)
WASHER, #10
(142-002AZ)
SCREW, #10-24
(P18-054)
WASHER, 1/4
(142-02AV)
NUT, 1/4-20 HEX
(161-026)
BRACKET
(140-787)
Figure 4
WASHER, #10
(142-002AZ)
SCREW, #10-24
(P18-054)
BOLT, 1/4-20 HEX
(160-231)
MG-WR
COVER
BRACKET
(140-787)
1/4" FASTENER (SUPPLIED
BY INSTALLER
KEY HOLES
MG-WR
ASSEMBLY
(S39-563)

Cleaning and Maintenance Instructions
IMPORTANT: Strong alkaline or acid-based chemicals and cleansers should not be used to
clean Terreon®. If these chemicals come in contact with the Terreon® surface,
wipe off the surface immediately and flush with soapy water.
Terreon® maintenance
The MG-WR waste receptacle cover is made of Terreon®, a solid cast polyester resin material.
Terreon® resists chemicals, stains, burns and impact, and is repairable with everyday cleaners or
fine grit abrasives. With regular cleaning, your MG-WR waste receptacle will provide years of
dependable service.
Stainless Steel Receptacle maintenance
Stainless steel is extremely durable, and maintenance is simple and inexpensive. Proper care,
particularly under corrosive conditions, is essential. Ordinary deposits of dirt and grease are quickly
removed with soap and water. Whenever possible, the metal should be thoroughly rinsed and dried
after washing. To remove tightly adhering deposits, use stainless steel polishing powder. In all cases,
rub in the direction of the stainless steel grain.
IMPORTANT: Never use ordinary steel wool or steel brushes on stainless steel. Always use
stainless steel wool or stainless steel brushes.
Avoid prolonged contact with chlorides, bromides, thiocyanates, and iodides on stainless steel
equipment, especially if acid conditions exist. Do not permit salty solutions to evaporate and dry on
stainless steel. The appearance of rust streaks on stainless steel leads to the belief that the stainless
steel is rusting. Look for the actual source of the rust in some iron or steel particles which may be
touching, but not actually a part of the stainless steel structure. NOTE: Strongly acidic or caustic
cleaners may attack the steel causing a reddish film to appear. The use of these cleaners should be
avoided.
IMPORTANT: To sustain original finish, additional care is recommended for dark colored solid
surfaces to maintain highest quality color. The original luster can be maintained
by periodically applying furniture polish, mineral oil or a solid surface cleaner or
polish. Length of time between applications varies with usage.
• For regular cleaning, use standard commercial or household products such as Formula 409® or Windex®.
• Remove tough stains with Ajax®, Comet® or Soft-Scrub® and a green Scotch-Brite® pad or
lightly sand in a circular motion with 240 grit wet/dry sandpaper. The finish can be renewed with
a maroon Scotch-Brite® pad.
• Remove scratches with a green Scotch-Brite® pad. The finish can be renewed with a maroon
Scotch-Brite® pad. Remove hard water build-up with a mild solution of vinegar and water.
* Use of brand names is intended to indicate a type of cleaner and does not constitute an endorsement.
** It is emphasized that all products should be used in strict accordance with package instructions.
•Repair kit: A repair kit is available from Bradley to repair/patch Terreon®. Contact your
Bradley representative to order a repair kit and be sure to specify color when ordering.
6Bradley Corporation • 215-1442; EN 02-800
Terreon® Waste Receptacle - MG-Series
MG-WR Installation Instructions