8
Refer to the Processing Guide B for
maximum quantities and recommended
speeds.
Before Use
• Pre-cut foods into small pieces for
easier chopping.
• Remove any bones, tendons and
gristle from meat to help prevent
damage to the blades.
• Make sure the anti-slip rubber ring
(7d) is attached to the bottom of the
chopper bowl.
Assembly and Operation
• Carefully remove the plastic cover from
the blade.
• The blade (7b) is very sharp! Always
hold it by the upper plastic part and
handle carefully.
• Place the blade on the center pin of
the chopper bowl (7c). Press it down
and give it a turn so that it locks into
place.
• Fill the chopper with food and put on
the lid (7a).
• Align the chopper with the motor part
(3) and click together.
• To operate the chopper, switch on the
appliance. During processing, hold the
motor part with one hand and the
chopper bowl with the other.
• Always chop harder foods (e.g.
parmesan cheese) at full speed.
• When chopping is complete, unplug
and press the release buttons (4) to
detach the motor part.
• Lift the lid up. Carefully take out the
blade before pouring out the contents
of the bowl. To remove the blade,
slightly turn it then pull it off.
Caution
• Do not use the chopper accessory (7)
to process extremely hard foods, such
as unshelled nuts, coffee beans,
grains, or hard spices e.g. nutmeg.
Processing these foods could damage
the blades.
• If using the appliance to purée hot food
ensure the liquid is not boiling. Allow
hot food to cool slightly to avoid risk of
scalding.
• Never place the chopper bowl in the
microwave oven.
«hc» Recipe example: Apple blueberry
purée
1 oz / 25 g blueberries
½ small apple (approx. 2 oz / 60 g)
• Peel the apple and chop into small
pieces.
• Place the apple in a pot with a small
amount of water.
• Steam the apple on a low heat until
soft for approximately 5 - 10 minutes.
Add the blueberries shortly before the
apple is done.
• Once cooled down, place the fruit
in the chopper and blend max.
15 seconds to a smooth consistency.
• Add water as needed.
Care and Cleaning (C)
• Always clean the hand blender
thoroughly after use.
• Unplug hand blender before cleaning.
• Do not immerse the motor part (3) in
water or any other liquid. Clean with a
damp cloth only.
• All other parts can be cleaned in a
dishwasher. Do not use abrasive
cleaners that could scratch the
surface.
• You may remove the anti-slip rubber
ring from the bottom of the bowl for an
extra thorough clean.
• When processing foods with high
pigment content (e.g. carrots), the
accessories may become discolored.
Wipe these parts with vegetable oil
before cleaning them.
5722112854_MQ523_Baby_USCA_S6-24.indd 85722112854_MQ523_Baby_USCA_S6-24.indd 8 19.09.17 10:4619.09.17 10:46
