BraunAbility REMOTE User manual

BRAUNABILITY REMOTE
Quick guide for Turny Low Vehicle
1. Download the BraunAbility Remote app from Google
Play or App Store.
2. Activate Bluetooth on your smartphone.
3. Run the Turny Low Vehicle to a position where the
Teach-in button (A) on the receiver is accessible.
4. Press the teach-in button x3 and follow the setup wizard
in the app.
How to set up the BraunAbility Remote app
Illustrated: Turny Low Vehicle, swiveled out to the right.
Note! Turny Low Vehicle swiveled out to the left have
the Teach-in button located on the opposite side.
427363-1 2019/04
BraunAbility Europe AB
Åkerivägen 7 Phone: [phone]
443 61 Stenkullen E-mail: [e-mail]
Sweden www.braunability.eu
Before using this device, download and read the
user manual available at: www.braunability.eu
Teach-in button

Adhesive pads
Towards the front cover
with circular holes.
Turny Low Vehicle, swiveled out to the right.
Flange
How to install the BraunAbility remote receiver
1. Swivel and extend the Turny Low Vehicle as far out as
possible to access the location for the receiver (A). Use
emergency mode if it does not reach far enough out,
see the user manual.
2. Remove the seat and the plastic cover.
3.
4. Connect the supplied cable between the control board
box and the receiver.
5. Place the receiver so that the Teach-in button points
towards the front cover with circular holes.
6. Attach the adhesive pads to the receiver’s bevelled edge
facing the center of the Turny Low Vehicle.
7. Align the receiver with the threaded hole in the Turny
Low Vehicle. Route the cable under the flange and press
the receiver against the flange. Fasten using the supplied
screw and washer.
8. Remount the plastic cover and the seat.
Towards the front cover
with circular holes.
Swiveled out to the rightSwiveled out to the left
Remove
Flange
Teach-in button
Control board box
Threaded hole Threaded hole