BraunAbility REMOTE User manual

Before using this device, download and read the
user manual available at: www.braunability.eu
1. Download the BraunAbility Remote app from Google
Play or App Store.
2. Activate Bluetooth on your smart-phone.
3. Press the Teach-in button (A) quickly three times in a
row and follow the setup wizard in the app.
4. If the Teach-in button on the receiver isn’t accessible,
run the lift until it is.
How to set up the BraunAbility Remote app
Teach-in button
427412-1 2019/04
Quick guide for E-series
BRAUNABILITY REMOTE
BraunAbility Europe AB
Åkerivägen 7 Phone: [phone]
443 61 Stenkullen E-mail: [e-mail]
Sweden www.braunability.eu

Adhesive pads
Teach-in button
Receiver
Adapter cable
Standard
hand held control
Standare cable
socket
How to install the BraunAbility remote receiver
1. Choose placement, either on or near the pump module.
Ensure that the Teach-in button on the receiver is easy
to access. Mount the receiver in step 5.
2. Disconnect the standard hand held control and replace
the standard socket with the adapter cable socket. Remo-
ve the standard cable socket by pushing out the 4 clips
from the inside. Reuse the clips when fitting the adapter
cable socket.
3. Connect the old socket to the adapter cable inside the
pump module and the hand held control on the outside.
4. Connect the adapter cable to the receiver.
5. Mount the receiver according to the illustration using the
supplied adhesive pads. In some cases it might be neces-
sary to drill (5 mm) and use the supplied clips.
6. Use the supplied cable tie to tidy up the excess cable.
Pump module Reuse x 4