8EN
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specied specications of power supply
voltage of the unit correspond to the specications of
your mains. When using the unit in the mains with 60
Hz frequency, the unit does not need any additional
settings.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
FAN ASSEMBLY
• Unscrew the base lock (14) from the stand (2) by
rotating it counterclockwise (pic. 1).
• nstall the base (1) on the stand (2), install the at
washer (13), screw the base lock (14) along the
thread, rotating it clockwise (pic. 2).
• Unscrew the fan clamp (12) not completely by rotating
it counterclockwise (pic. 3).
• Mount the fan body (11) onto the stand (2), screw
in the fan clamp (12) by rotating it clockwise. When
screwing the clamp (12) do not apply too much eort
(pic. 3).
• Unscrew the blade lock (5) by turning it clockwise.
Unscrew the rear grid fastening nut (7) by turning it
counterclockwise (pic. 4)
• Match the guides on the motor unit with the
corresponding openings on the grid (8) and install the
rear grid (8) on the motor unit, x it with the nut (7),
turning it clockwise along the thread (pic. 5, 6).
• Install the blades (6) on the electric motor axis (9), and
x them with the lock (5), turning it counterclockwise
along the thread, hold the blades (6) with your free
hand (pic. 7, 8).
• Open the grid clamps, match the front (4) and rear (8)
grids, close the clamps, make sure that the grids (4
and 8) are properly xed (pic. 9, 10).
• Unscrew the xing screw at the bottom part of the grid
(pic. 11), set the clamp to the correct position (pic. 12),
tighten the xing screw (pic. 13).
Remote control (21)
• Before using the remote control (RC) (21) open
the battery compartment lid (27) and insert 2 «AA»
batteries (supplied with the unit) into the battery
compartment strictly following the polarity, close the
battery compartment lid (27).
Note: if there is an isolating insert in the battery
compartment, remove it.
• If you are not going to use the remote control for a long
time, open the lid (27) and remove the batteries from
the remote control (21) battery compartment.
• Battery leakage may cause injury or damage to the
remote control (21), to prevent damage to the remote
control (21), follow the instructions below:
- use only the «AA» batteries;
- do not use old and new batteries at the same time;
- do not recharge the batteries;
