brel-motors DD-2762H User manual

BREL motors is part of:
Manual Brel 15-channel bi-directional emitter TDBU motor
Type DD-2762H
Read the manual before you begin the installation. If these instructions are not followed,
this may lead to defects and injury in which warranty can’t be claimed.
NOTE:
This handtransmitter is only suitable for BJE24-TD motor!
This manual can only be used to connect the hand-held transmitter to the motor,
NOT to adjust the motor!
For all manuals, visit: www.brel-motors.nl
____________________________________________________
Technical specifications Type DD-2762H
•Battery type: 3V 1x CR2450
•Frequency: 433,92MHz
•Emission power: 10 MW
•Emission distance: 200 meter open field, 2 walls 35 meter.
____________________________________________________
Button specifications
____________________________________________________
Usermode
When the remote control is locked, you can operate the motor, but not program it.

____________________________________________________
Pairing the remote control transmitter in the memory of the motor
METHOD 1 1x P2-A- 1x 1x P2-A- 1x 1x P2-A- 2x 
Go to the existing Press 1x P2-A of Press 1x P2 of Go to the new channel b.Press P2-A
channel a. the existing channel a. the existing channel a.of the additional channel b.
The product makes The product makes The product makes 2x up-down
1x up-down movement 1x up-down movement movement and/or beeps 3x
and/or beeps 1x. and/or beeps 1x. for confirmation.
To delete a channel you have to repeat the above.
-----------------------------------------------------------------------------------------------------------------------------------------------------
METHOD 2 1x P2-A- 1x 1x P2-A- 1x 1x STOP-A- 2x 
Go to the existing Press 1x P2-A of Press 1x P2-A of Go to the new channel b.Press
channel a.the existing channel a. the existing channel a.STOP-A button of the additional
The product makes The product makes channel b.The product makes
1x up-down movement 1x up-down movement 2x up-down movement and/or
and/or beeps 1x. and/or beeps 1x. beeps 3x for confirmation.
To delete a channel you have to repeat the above.
-----------------------------------------------------------------------------------------------------------------------------------------------------
Adding a replacement handtransmitter, in case of loss/failure of the old hand transmitter
After power has been applied to the motor, press stop within 10 seconds.
METHOD 3 P1 until 1x Hold STOP A until 2x 
Press and hold P1 until the Hold down stop A until the motor moves
motor 's moving back and forth. back and forth 2x and/or beeps 3 times.
____________________________________________________
Set up number of channels
In programming mode; press the up or down button. You can stop quickly.
If you want to change the locked channels, you can repeat above.