Breo iSee310 User manual

USER
MANUAL
iSee310
EYE MASSAGER

Thank you for purchasing
BREO iSee310.
Please read this manual carefully before using
the product, and keep it in a safe place for future
reference.

Introduction
Inside the Package
Function Deployment
Operation
Precautions
Troubleshooting & Technical Parameters
3
3
4
6
Preparation 5
7 -- 8
9
Contents
2

3
Inside the Package
The package includes: Main Unit, Controller, AC Adapter, Batteries, User
Manual.
User Manual
BatteriesAC Adapter
Controller
Main Unit
Introduction
iSee310 adopts air pressure and hot compress massaging technology.
It rubs, presses, hot compresses, and massages the ocular region in order
to relax it.

B . Operating Buttons
C .DC Power Port
D .Battery Cover
E .Main Unit
Controller
Function Deployment
Main Unit
Fabric cover
E
A . LCD Screen
A
D
B
C
4

5
Prior to use, check the integrity of the machine and
accessories:
No damage on connection between controller and main unit
Battery power is sufficient
No damage on AC adapter
* Choose power option #1 OR #2.
Power Options
Wear
Preparation
Open the battery cover on the back of the controller.
Install 3 AA batteries in accordance with the positive and
negative poles.
Close the battery cover.
Insert the AC adapter in the controller’s DC port.
Connect the other end to AC power socket.
a.
b.
c.
1. Batteries
a.
b.
c.
a.
b.
2. AC Adapter

6
Operation
Power on – Press and hold Button
Preset default is air pressure + hot compress for 15 minutes.
Manually operate related function buttons to switch between
air pressure and hot compress modes.
Power off – Press and hold Button again
Manual mode
ON-OFF/Hot compress Button – Press and hold ON-OFF to start
up the machine (into preset mode); Press the same button to
select hot compress modes (low or high temperature)
Press and hold it again to shut down the machine
Mode/Air pressure Button – Press Mode button to select from 3
modes (Relaxing / Soft / Comfortable)

7
Precautions
Please read the manual carefully and operate accordingly.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
People who suffer from brain disease or have undergone brain surgerya.
b.
c.
Children under 7 years old cannot use the massager.
This massager should not be used by:
Take off contact lenses/eye glasses before use.
Put on/wear the unit first BEFORE turning the power on.
Do not use while walking or driving.
Keep your eyes closed for a few seconds after use,then open
them slowly.
Keep the massager away from humidity, heat, and/or corrosive gas.
If the massager will not be used for a long time, remove the batteries
to avoid battery leakage.
This massager is designed as a personal care product. It is not for
diagnosis/treatment of any health disorder, nor meant for
commercial use.
To clean, wipe with aseptic cotton and alcohol. Do not wash or
immerse in water.
People who are suffering from glaucoma, retinoschisis, or other
serious eye diseases
People who have physical or mental disorder

This product is not a substitute for healthcare professionals' advice
and treatment. In case of doubt or if necessary, please consult your
healthcare professional.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including inter-
ference that may cause undesired operation.
Please note that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the fol-
lowing measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
12.
13.
14.
15.
8

Troubleshooting &
Technical Parameters
When operational problems occur, please refer to the chart below.
Do not disassemble the machine or try to repair it by yourself.
Technical Parameters
Power supply：
Ideal environment：
Dimension ：
Net Weight：
Power：
Air pressure strength：
Heating temperature：
DC: 4.5V 1000mA
Temperature: 5°C - 40°C
Relative humidity: ：≤80%
Main Unit: 220mm X 100mm X 86mm
Controller: 184mm X 36mm X 39mm
390g
4.5W
5hpa-400hpa
30°C-45°C
Problem Possible Reason Possible Solution
Power-ON failure
Cable is broken / in bad
condition

Check the condition of the cable
Batteries are low / out Change batteries 
Batteries are not installed
correctly

Check if positive/negative poles of batteries
are positioned right

Make sure the batteries are snug in place
 
AC adapter is not connected
properly
Check the connection of the AC adapter to
the power socket .
Weak heat or air
pressure

Batteries are low / out
Change batteries 
Make sure the batteries are installed
correctly and snug in place

9