BRIO CLNLPOU520SCFF2 User manual

Before first use and after replacing the filters each time, place a bucket below
the Drain Outlet(part 21) , open the drain outlet. Flush the filters for 5-10 minutes
ou until the water runs clear. Discard the water, close the drain outlet.

Step 1：Mix 1.5 gallons of water with 50g citric acid crystals（not include）or cleaning solution of your choice.
Step 2：Pour this cleaning solution into the 5 gallon water bottle.
Step 3：Turn the valve above the sediment filter to the off position（perpendicular to the tubing).
Step 4：Place a bucket below the Pump Cleaning Drain.
Step 5：Remove the plug of the Pump Cleaning Drain by pressing in the grey
ring and pulling on the plug simultaneously.
Step 6：Press Cold water button for 3 seconds to activate the pump. The pump
will begin pumping the cleaning solution from water bottle out through
the Pump Cleaning Drain into your bucket.

Step 7：Once the cleaning solution is depleted, refill another gallon of tap water into the water bottle.
Step 8：Once the water stops flowing out of the Pumping Cleaning Drain，you can replace the plug into the
Pumping Cleaning Drain.
Step 9：Turn the valve above the sediment filter to the on position（parallel to the tubing）
Enjoy your water.