Britax ZOOM WALKER - SERIES WM-2112US User manual

ZOOM WALKER
4001008
WM-2112US
ZoomWalkerInstructions.indd 1 3/9/08 3:20:29 PM

NOTE: The child must be removed from the walker
before releasing the lock to lower the walker, to avoid
injury. Be sure to follow these instructions carefully to
avoid the top tray falling down onto your hand.
A. Remove the child from the walker.
B. There are two safety adjusting locks under the tray.
C. First press the RED lever and while holding in, at the
same time press the white button in. Hold together
and slowly lower the walker down to folded position.
D. Before completely lowering down, take care of your
hand position and make sure you have enough space.
To adjust the seat height from highest to lowest of
three positions:
E. Remove the child from the walker
F. Support the upper tray with one hand. Activate both
safety locks and the tray will begin to lower. Let go of
both locks and allow the tray to SLOWLY lock into a
lower position. Press down lightly on the upper tray to
conrm it is locked into place.
5. CLOSE/LOWER AND ADJUST WALKER HEIGHT
B.
C.
C.
D.
F.
ZoomWalkerInstructions.indd 2 3/9/08 3:20:31 PM

A. 1 x Walker Frame
B. 1 x Seat
C. 2 x Swivel Wheels
D. 1 x Activity Centre Tray
A. Position the activity tray on top of the upper tray as
shown and lay it down at.
B. Hold the activity down with one hand. Then from
under the upper tray, push the white engagement pins
up into the activvity tray cavities and turn to the right
to lock into place.
C. To remove, turn the pins and remove activity tray.
A. B.
C. D.
A.
B.
B.
ZoomWalkerInstructions.indd 3 3/9/08 3:20:34 PM

A. Turn walker upside down on top of the carton. Insert
the end of the wheel posts all the way into the
holes at the corner of the walker base using moderate
force.
NOTE: Clean grip pads regularly, using warm water
with a household soap or mild detergent to maintain
stopping performance.
A. Turn walker right side up.
B. Position one hand underneath the top edge of the tray,
and the other hand on the top of the outer base
frame.
C. There are three height adjusting positions. Lift the tray
slowly while holding down the base until you hear the
tray lock into the rst/lowest position. (If raised past
the rst/lowest position then see step 7D/E to lower it.)
A. The seat needs to be attached to the frame. There are
six attachment points at the rear and four at the front.
B. Position the seat into the upper tray cavity.
C. Begin to attach the seat from the rear by locating the
plastic pins over the engagement holes. One at a
time, slide each pin into the holes and lock into
position. Make sure all six pins are engaged. Pull up on
the seat to conrm. Repeat steps if not locked into
upper tray.
D. Attach the seat to the front section. Locate the plastic
pins into the holes and push down until locked.
Pull down by the fabric to lock the pins if a little tight.
Make sure all four plastic pins are engaged.
NOTE: You will need 2 x AA batteries for the lights and
sounds. Batteries are not included.
A. Turn over the activity tray, undo the battery cover
screw and remove the cover. Fit 2 x AA batteries in
the direction shown. (Check that the batteries are
tted correctly by pushing one of the coloured
buttons.) Replace cover and secure with screw.
A.
A.
B.
C.
A.
A.
B.
C. D.
C.
ZoomWalkerInstructions.indd 4 3/9/08 3:20:39 PM