Britton Cleargreen BS5 User manual

E
1 - 7
Before Installation:
Check the contents of the pack carefully before installation.
●The bath MUST be installed level and fully sealed to the tiles.
●Handle with care. Impacts can damage both the glass and the frame.
●Check for any hidden pipes or cables before drilling holes in the wall.
●The wall fixings supplied may not be suitable for your installation. You may need to source alternatives
depending on the construction of the wall you are fixing to.
●Follow each step in turn.
Care and Cleaning:
●Do not use solvents or abrasive material or chemicals to clean the enclosure.
●Only clean using soapy water and a soft cloth, rinse thoroughly afterwards.
RH
LH
Four panel bathscreen
88cm x 145cm - BS5
●

E
2 - 7
Parts supplied:
Tools required:
SILICONE
Ø6.0mm
Ø2.8mm
Four panel Bathscreen 88cm x 145cm - BS5
ST4*40mm ST3.5*10mm
B016 B014 B013 B012
B111
3x x3x3 3x
1x
B112
x1x1
B114
1x
B113
B114
B113
B112
B013
B111
B012
B016
B014

E
3 - 7
1
2
B111
Ø6.0mm
B016 B014
R H L H

E
4 - 7
3
Firmly push the screen profile onto the wall profile, ensure the screen profile is
as close to the wall as possible. Before securing the screen to the profile ensure
that the gap between the screen and the bath is equal along its whole length.
4
Ø2.8mm
B012
B013
B112
B113
B114
ab
cd
ef
Please follow this step if the optional water barrier is desired.

E
5 - 7
5
24H

E
6 - 7
Maintenance
If necessary,please follow the below steps to replace the bottom sealing strip.
1. Fold the fourth glass as show below.
2. Take out existing sealing strip.
4. Insert the new sealing strip.
5. Silicone both ends.
24H
3. Remove the glue residual from the glass on both ends.

E
7 - 7
Maintenance
If necessary, please follow the below steps to adjust the sealing strip if it does not stay in position properly
or the operation is stiff.
1. Take off the covers.
1
2
3
4
6
7
8
9
2. Loosen the screws.
3. Disassemble the hinge.
4. Take out the sealing strip.
5. Apply some transparent
lubricating oil onto the surface
of sealing strip evenly with the
sponge or soft cloth.
6. Install the sealing strip back to
the frame. The sealing strip
should be straight and even
from the top to the bottom.
7. Install the hinge.
8. Tighten the screws.
9. Put back the covers onto the
frames.