Broadrack PD Series User manual

PD series
1U Rack Mount LCD Panel Drawer
Quick Installation Guide
Rev 1.0

PD series QIG
1
Notes:
1. Please check all peripherals according the list before installation. To make
sure that the whole unit was not damaged and lost during shipping process. If
you encounter any problem, please contact your dealer.
2. Before installation, make sure all peripherals and computers have been
turned off.
3. This product required front and rear mounting brackets. Pre-configure the
deep of the rack to find the best rear bracket kits for your usage.
4. The standard rear bracket kits are for 420~830 mm PD-115 / PD-117
(480~895 mm - PD-119) as below figure,contact your dealer if you need
more longer rear bracket.
5. Reliable grounding of rack-mounted equipment should be maintained. Particular
attention should be given to supply connections other than direct connections to
the branch circuit.

PD series QIG
2
Hardware kits contents:
Packing contents (PD-115 / PD-117 / PD-119):
1. Short Single Bracket x 2
2. Long Assembled Bracket x 2
3. Support Bracket x 2
4. Metal Plate x 2 (For short single bracket)
5. Copper Ring x 4 (For short single bracket)
6. Flat Screw x 4 (For short single bracket)
7. Cap Screw x 28
8. Key x 2

PD series QIG
3
PD-115 / PD-117 PD-119
Short single bracket
420-470 mm 480-530 mm
Long single bracket
none none
Long assembled bracket 535-680 mm 595-745 mm
Long assembled bracket
w/support bracket 680-830 mm 745-895 mm
Cabinet support depth

PD series QIG
4
Installation steps (PD-115 / PD-117 / PD-119):
Second person required for rear support during installation
A. Rack Depth 420 ~ 470 mm – PD-115 / PD-117 (480 ~ 530 mm – PD-119)
1. Release the thumb screw of front bracket. (both side)
2. Install front bracket from each side using cabinet screws.
3. Install rear bracket from each side.
4. Install rear bracket from each side using cabinet screws.

PD series QIG
5
B. Rack Depth Above 535 mm – PD-115 / PD-117 (Above 595 mm – PD-119)
1. Remove the screw of long assemblied bracket and keep screws.
2. Combine (I) to console from each side using cap screw. (5 pcs each side)
3. Combine (I) and (II) from each side. (7 pcs each side)
4. Release the Thumb Screw of front bracket and Install front bracket from each
side using cabinet screws.

PD series QIG
6
5. Combine (I)+(II) and (III) using the original screw and Install rear bracket from
each side using cabinet screws.
Please use support bracket to replace (III) when rack depth is
more than 680 mm – PD-115 / PD-117 (745mm – PD-119)
6. Finish Installation as below.
7. Attach provided cable and power cord to use.