broda HSP User manual

HSP Padding Installation
Page 1of 3FORM-03DOC-xxx Rev. 0
Parts Required:
Tools Used:
Step
Execution
Figures
1
Locate the front cross piece of the seat frame. Starting from under the
chair seat, pass one end of the thigh belt between the second and
third strap from the front of the seat
2
For Pedal Rocker attachment, locate the front frame piece attached to
the seat frame (resembles a handle)
3
Pass the other end of the Thigh Belt though the same spot in the chair
seat. Ensure that the center strap of the Thigh Belt is looped around
the front cross piece of the seat frame
4
One padded section of the Thigh Belt passes over each thigh. Connect
the snap buckles behind the chair. Do not fasten around the cylinder
or cable behind the chair. Tighten the straps as necessary

HSP Padding Installation
Page 2of 3FORM-03DOC-xxx Rev. 0
5
Take the wing cover and slide it over top of the wing from the outside.
6
It should slide on tightly, and will wrap around the strap and the flap
will Velcro shut on the inside portion of the wing.
7
Take the pad and clip the bottom buckles underneath the footplate
portion of the footrest.
8
Take the straps and wrap them around the calf portion of the footrest
and buckle.
9
Take the flap portion of the pad and slide it underneath the seat pad.
10
Take the straps with “D” rings and attach them around the seat frame
and tighten.

HSP Padding Installation
Page 3of 3FORM-03DOC-xxx Rev. 0
11
Unbuckle attachment straps and position the shoulder bolster to the
top of the wing
12
Attach the straps around the wing cover and secure with the buckles
provided. Use the strap and "D" ring to secure the lower extended
portion of the bolster to the back cane
For more information, please contact Broda Customer Care at 1-800-668-0637