Brother MFC-L2710DN User manual

Reset procedure for Brother MFC-L2710DN/MFC-L2710DW
1)
Open
the printer Front
-
cover
;
2) Press Clear and Stop/Exit button at the same time and then press Clear one more time. This step
must be done very quickly;
3) Press the down-arrow button and select K.TNR-HC;
4) Press OK to confirm the reset process and Accepted will appear on the printer’s display.
Picture below is showing the buttons mentioned on the Step 3 and 4:
5) Close the printer Front-cover;
6) Printer is now ready for printing.
Reset procedure for Brother HL-L2310D
1.
Open the front cover and leave it open while completing the follo
wing steps:
2. Turn the printer off.
3. Hold the ‘go’ button (or ‘start’ button) while turning the printer on. All panel lights should be on.
4. Release the ‘go’ button (or ‘start’ button).
5. Press the ‘go’ button (or ‘start’ button) 2 times.
6. Pause. All panel lights should be on.
7. Press the ‘go’ button (or ‘start’ button) 5 times. The toner light should be off (the error may be
flashing). The paper light should be on or flashing.
8. Close cover. The ready light should be the only light on.

Reset procedure for
Brother HL-L2350DW/HL-L2357DW/HL-L2370DN/HL-L2375DW
1)
Open
the printer Front
-
cover
;
2) Press Back and Go button at the same time and then press Back one more time. This step must
be done very quickly;
3) Press the down-arrow button and select TNR-HC;
4) Press OK to confirm the reset process;
5) Press the down-arrow button and Accepted will appear on the printer’s display.
Picture below is showing the buttons mentioned on the Step 3 and 4 and 5:
6) Close the printer Front-cover;
7) Printer is now ready for printing.

Reset procedure for
Brother MFC-L2730DW / MFC-L2750DW
1)
Open the printer Front
-
cover;
2) Press Back and Stop button at the same time and quickly release, then press Back again within 2
seconds:
3) Printer shows on the display the Reset Menù as follow:
Select TNR-HC from the touch screen display and hit Yes for confirmation;
4) Accepted will appear on the printer’s display;
5) Close the printer Front-cover;
6) Press the Home button on the printer to return to the main Menù
7) Printer is now ready for printing.

RESET PROCEDURE “REPLACE TONER “ MESSAGE FOR DCP=L2550 DW -HL-L2390DW- MFCL2710W
1. Open printer FRONT COVER
2. Press CLEAR and STOP/EXIT button at the same time and then CLEAR one more time.
This step must be done quickly
3. Press down arrow button and select K.TNR-HC (TN760)
4. Press OK to confirm the reset process and ACCEPTED will appear on the display
5. Close printer FRONT COVER
6. Printer is now ready for printing