Bryant LEGACY 558J Installation and user guide

558J
SINGLE PACKAGE ROOFTOP COOLING ONLY HORIZONTAL AIR FLOW UNIT
WITH PURONR(R--410A) REFRIGERANT
15, 17.5, 20, 25 TONS -- (MODEL SIZES: 18, 21, 25, 29)
Submittal Data
Certified to ISO
Use of the AHRI Certified
TM Mark indicates a
manufacturer’s
participation in the
program For verification
of certification for individual
products, go to
www.ahridirectory.org.
9001
DESCRIPTION
558J (model sizes 18, 21, 25, 29) units are single--packaged
dedicated horizontal air flow electric cooling only units that
are pre--wired and pre--charged with PuronR(R--410A) HFC
refrigerant. Electric heat is available as a field--installed
accessory. The units are factory tested in the cooling mode
STANDARD FEATURES
Base Unit
SPuron (R--410A) HFC refrigerant
SEER’s up to 11.0
SIEER’s:
— up to 11.2 with single speed indoor fan motor
— up to 12.9 with 2 speed/VFD indoor fan motor
SRated in accordance with AHRI Standards 340/360
SDesigned in accordance with Underwriters’
Laboratories Std 1995
SListed by ETL and ETL--Canada
SASHRAE 90.1 energy compliant
STwo--stage cooling capacity control
SNon--corrosive composite sloping design; side or center
drain condensate pan. Meets ASHRAE Standard 62
SStandard cooling operating range from 35_Fupto
115_F(2_Cupto46_C).
SDedicated horizontal airflow models. No special kits
required
STwo--inch disposable return air filters on slide out track
SProvisions for thru--the--bottom power entry capability
as standard in an environmentally protected area
SSingle point electric connections
S24--volt control circuit protected with resettable circuit
breaker and 75--VA transformer
SBelt drive, constant torque, permanently lubricated
evaporator--fan motor
SBlower bearing extended lubrication line on all sizes
STotally enclosed condenser motors with permanently
lubricated bearings
SLow--pressure and high--pressure switch protection
SFull perimeter base rail with built--in rigging adapters
and fork truck slots
SCentral Terminal Board facilitating simple safety circuit
troubleshooting and simplified control box arrangement.
SHigh performance belt drive motor with variable pitch
pulleys, quick adjust belt system and fan belt protection
Cabinet
SAccess panels with easy grip handles
SInnovative, easy starting, no--strip screw feature on unit
access panels
SPre--painted exterior panels and primer--coated interior
panels tested to 500 hours salt spray protection
SFully insulated cabinet
Refrigerant System
STXV refrigerant metering device on each circuit
SLiquid line filter drier on each circuit
SScroll compressors with internal line--break overload
protection
SCopper tube, aluminum fin evaporator coil
SRound Tube/Plate Fin (RTPF) condenser coils on all
model sizes.
Standard Parts Warranty
S5--year compressor parts
S5--year electric heater parts (field--installed)
S1--year parts

2
PERFORMANCE DATA
Unit Operating Weight lb
Cooling
Gross Total Capacity: Btuh
at Condenser Air Temperature _F
Gross Sensible Capacity: Btuh
Compressor Power Input: kW
Indoor Entering db _Fwb _F
Airflow CFM External Static Pressure in.wg
Indoor Fan Motor Size Hp
Exhaust Fan Motor Size Hp
Curb Weight lb
Heating
Heating Capacity:
Stage 1 Btuh
Stage 2 Btuh
Heating Capacity Total Btuh
Stage 1 kW
Stage 2 kW
Heating Capacity Total kW
ELECTRICAL DATA
Power Supply to Unit Volts Phase Hz
Minimum Circuit Amps Maximum Overcurrent Protection
SUBMITTAL DATA
Job Name
Architect
Engineer
Contractor
Unit Designation
558J--18-- 29H

3
FACTORY--INSTALLED OPTIONS (FIOPs)
jEconomizer with DRY BULB sensing and barometric
relief
Standard Air Leak Dampers —
fModels with W7212 controller provides standard
non--diagnostic control. EconoMi$er IV.
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er 2.
jEconomizer with ENTHALPY sensing and barometric
relief
Standard Air Leak Dampers —
fModels with W7212 controller provides standard
non--diagnostic control. EconoMi$er IV.
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er 2.
jEconomizer with DRY BULB sensing and barometric
relief
ULTRA LOW LEAK Air Dampers —
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements --
plus 5 year limited parts warranty. EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements --
plus 5 year limited parts warranty. EconoMi$er 2.
jEconomizer with ENTHALPY sensing and barometric
relief
ULTRA LOW LEAK Air Dampers —
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements --
plus 5 year limited parts warranty. EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements --
plus 5 year limited parts warranty. EconoMi$er 2.
j2--Speed Indoor Fan Motor system utilizes a Variable
Frequency Drive (VFD) to automatically adjust the indoor
fan motor for 2 speed indoor fan motor control. Conforms
to ASHRAE 90.1 2010 Standard – section 6.4.3.10.b.
2--speed indoor fan motor is standard on 29 size models.
jRTU Open multi--protocol controller communicates to
LON, MODBUS, BACNET and Johnson N2 protocols.
j2 position motorized outdoor air damper
j25% Manual outdoor air damper
jPerfect Humiditytdehumidification system
jNon--fused disconnect
jPowered 115--volt convenience outlet
jNon--powered 115--volt convenience outlet
jMedium and High static motor options
jHigh static evaporator fan motor
jReturn Air smoke detector
jSupply Air smoke detector
jCO2sensor
jCondenser hail guard -- louvered style
jSpecial coating protection for evaporator
and condenser coils
jHinged access panels
OPTIONAL WARRANTIES
jComplete Unit Parts only up to 5 years
jComplete Unit Parts and Labor up to 5 years
Many other optional warranties are available.
See the Commercial Start--Up and Optional Extended
Warranty Price price pages for further information.
558J--18-- 29H

4
FIELD INSTALLED ACCESSORIES
jEconomizer with DRY BULB sensing and barometric
relief
Standard Air Leak Dampers —
fModels with W7212 controller provides standard
non--diagnostic control. EconoMi$er IV.
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er 2.
jEconomizer with ENTHALPY sensing and barometric
relief
Standard Air Leak Dampers —
fModels with W7212 controller provides standard
non--diagnostic control. EconoMi$er IV.
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements. EconoMi$er 2.
jEconomizer with DRY BULB sensing and barometric
relief
ULTRA LOW LEAK Air Dampers —
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements.
EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements.
EconoMi$er 2.
jEconomizer with ENTHALPY sensing and barometric
relief
ULTRA LOW LEAK Air Dampers —
fModels with W7220 controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements.
EconoMi$er X.
fModels with RTU Open controller meets California
Title 24 (section 120.2) Fault Detection and
Diagnostic (FDD) requirements, has return, outside
air and relief damper leakage that meets Title 24
(section 140.4 and ASHRAE 90.1) requirements.
EconoMi$er 2.
jDisplay Kit for Variable Frequency Drive (VFD),
2--Speed Indoor Fan Motor System. Allows additional
set up and diagnostics of the unit VFD controller. Can
be unit mounted or used with any other compatible
VFD model as a reusable device.
jElectric heater(s)
jSingle point kit
jPower exhaust -- centrifugal fan design
jTwo--position motorized outside air damper
jManual outside air damper 25%
jRoofcurb -- 14 inch (356mm) tall
jRoofcurb -- 24 inch (610mm) tall
jThru--the--bottom connections--electrical
jCondenser hail guard -- louvered style
jPhase monitor (loss of phase/phase reversal)
jWinter start kit, down to 25_F(--4_C)
jLow ambient head pressure controller,
down to --20_F(--29_C)
jTime Guard II compressor anti--cycle protection
jFour inch filter tracts
jReturn Air smoke detector
jSupply Air smoke detector
jThermostats and Sensors
Economizer Sensors
jSingle Dry bulb control
jDifferential Dry bulb control
jSingle enthalpy control
jDifferential enthalpy control
jCO2-- wall mounted
jCO2-- duct mounted
jCO2-- unit mounted
558J--18-- 29H

5
CERTIFIED DIMENSION 558J*18
C13749
558J--18-- 29H

6
CERTIFIED DIMENSION 558J*18
C13750
558J--18-- 29H

7
CERTIFIED DIMENSION 558J*21, 25
C13755
558J--18-- 29H

8
CERTIFIED DIMENSION 558J*21, 25
C13756
558J--18-- 29H

9
CERTIFIED DIMENSION 558J*29
C13761
558J--18-- 29H

10
CERTIFIED DIMENSION 558J*29
C13762
558J--18-- 29H