
580J***(D,F)
SINGLE PACKAGE ROOFTOP
GAS HEATING/ELECTRIC COOLING UNIT
TWO STAGE COOLING CAPACITY CONTROL WITH NOVATIONtCOIL
SIZES 08, 12, 14 WITH PURONR(R--410A) REFRIGERANT
Submittal Data
®
This product has been designed and manufactured
to meet Energy Star®criteria for energy efficiency.
However, proper refrigerant charge and proper air
flow are critical to achieve rated capacity and effi-
ciency. Installation of this product should follow all
manufacturer’s refrigerant charging and air flow in-
structions. Failure to confirm proper charge and
air flow may reduce energy efficiency and short-
en equipment life.
DESCRIPTION
580J***(D,F) units are high--efficiency, single--packaged
electric cooling, gas heating units that are pre--wired and
pre--charged with PuronR(R--410A) HFC refrigerant.
Units utilize an all aluminum flat micro--channel tube
with louvered fins condenser coil—NOVATIONt.The
units are factory tested in both heating and cooling modes.
These units meet the ASHRAE 90.1--2007 and Energy
Star minimum efficiency levels as well as also meeting
2010 efficiency standards.
STANDARD FEATURES
Base Unit
SPuron (R--410A) HFC refrigerant
SARI certified efficiency levels up to 11.1 EER
SRated in accordance with ARI Standard 360
SDesigned in accordance with Underwriters’ Laboratories Std
1995 and listed by UL and UL, Canada
STwo--stage cooling capacity control
SNon--corrosive composite sloping design; side or center drain
condensate pan. Meets ASHRAE Standard 62
SStandard cooling operating range from 40_Fupto115_F
(4_Cupto46_C). Field installable accessory extends the
minimum down to --20_F(--29_C).
SConvertible from vertical to horizontal airflow for slab mounting
STwo--inch disposable return air filters
SThru--the--bottom power and gas entry capability
SSingle point gas and electric connections
S24--volt control circuit protected with resettable circuit breaker
and 75--VA transformer
SBelt drive, constant torque, permanently lubricated
evaporator–fan motor
STotally enclosed condenser motors with permanently lubricated
bearings
SLow--pressure and high--pressure switches
SFull perimeter base rail with built--in rigging adapters and fork
truck slots
SCentralized Terminal Board for component and unit wiring
connections
Cabinet
SAccess panels with easy grip handles and NO--STRIP screw
collar
SPre--painted exterior panels and primer--coated interior panels
tested to 500 hours salt spray protection
SFully insulated cabinet
STool--less filter access door
Refrigerant System
SAcutroltrefrigerant metering system
SLiquid line filter drier
SScroll compressors with internal line--break overload protection
SCopper tube, aluminum fin evaporator coil
SNOVATION all aluminum condenser coil
SRemovable gauge line plugs for reading refrigerant pressure
with unit panels in place
Gas Heat
SIGC solid--state gas heat exchanger control for on--board
diagnostics, anti--cycle protection, LED error code designation,
burner control logic and energy saving indoor fan motor delay
SGas efficiencies up to 82%
SDesigned in accordance with ANSI Z21.47 (design and test
standard for gas furnaces) and ANSI Z233.1 (National Fuel Gas
code relating to appliance installation requirements)
SInduced draft combustion
SRedundant gas valve, with up to 2 stages of heating
SFlame roll--out safety protector
SSolid--state electronic direct spark ignition system