Buchi S-300 User manual

11594369A en
MiniSprayDryer S-300 in closed mode with Inert Loop
06.2022
BÜCHI Labortechnik AG
Meierseggstrasse 40
Postfach
CH-9230 Flawil 1
E-Mail: [email protected]
Reading and following the instructions in this document does not replace reading and
following the instructions in the operation manual.
The following instruments are necessary for the closed mode with inert loop:
MiniSprayDryer S-300
Inert Loop B-395 SE
2
3
4
5
1
6
Assembling instruction:
uAttach the tubing pieces.
uClose the easy clamp.
uTighten the nut.
1
2
2
3
Precondition:
RThe spray dryer is prepared. See operation manual "MiniSprayDryer S-300"
RThe inert loop is prepared. See operation manual "Inert Loop B-295 SE"
RThe tubing inside the MiniSprayDryer S-300 is installed. See installation manual
"MiniSprayDryer S-300 in open pressure mode" or "MiniSprayDryer S-300 in open
suction mode"
MiniSprayDryer S-300 in closed mode with Inert
Loop
Installation Manual

2/2 Installation Manual MiniSprayDryer S-300 in closed mode with Inert Loop
uConnect the Inert Loop communication cable to the related connection on the spray dryer. See
Configuration
uInstall the process gas tube to the inert loop marked Inlet.
uInstall the gas tube to the connection marked Inlet on the spray dryer.
uInstall the process gas tube to the inert loop marked Outlet.
uInstall the gas tube to the connection marked Outlet on the spray dryer.
uInstall the tube to the filter. See operation manual "MiniSprayDryer S-300"
uInstall the gas tube to the connection marked Filter on the spray dryer.
BÜCHI Labortechnik AG