Bullet tools CenterFire Shut-n-Cut User manual

STEP 1: With your Shut-n-Cut upside down, insert leg into each end until the click.
Turn back over and set on a level surface.
2
2
1
ASSEMBLY
Please Review and Verify Parts Included in Box:
1. SNC Body
2. Leg x 2
3. Knife Kit
3
Quick Start Guide
for Shut-n-Cut #BT51-1927
1
1
2
2
2

INSTRUCTIONS FOR USE OF YOUR SHUT-N-CUT
Insert knife
in slot
• Presstheredtriggertounlocktheclamparm.Pivot
theclamparmtothefull‑openposition.
• Set insulation on the lower clamp bar so that the
cutting slot is in-line with the desired cut.
1
1
2
2
• Close the clamp arm to compress the product,
pressing down on handle until the trigger engages.
• Insert the Centerre Insulation Knife (included)
intothecuttingslotontheclamparm.
• Cutthroughtheinsulationproductwithasawing
motion,drawingthebladetowardyou.
PRT‑INS‑1950RevA.1.19©2019BulletTools
For warranty info, accessories, & tips on
using and maintaining your Shut-N-Cut,
go to BulletTools.com
Hayden, ID USA • 208-772-0175
SAFETY
1) This machine has several
pinch points. Do not adjust
or collapse machine when
ngers are in the way.
2) To avoid tipping and/or
rocking, only operate on a
level, stable, at surface.
3) Wear safety goggles and all
other OSHA recommended
safety gear when cutting.
INSULATION
45
NOTE: The CenterFire Straight
Blade works best when
held at a 45 angle to the
product.