Burnside T400 User manual

Getting started
• Removeanyshippingtape,
thenpulloutthebattery
insulatingtab.
• Carefullyslideopenthebattery
compartment.
• InsertastandardsizeSIMcard
facedownintotheslot,withthe
SIMcard’schamferedcorner
facingout.
• Replacethecover.
• Iftheunitwillbewallmounted,
insertthesuppliedlocking
screwtosecurethebattery
compartmentlid.
• PlaceyourT400terminal
inasuitablelocation,but
keepitatleastonemetre
fromyourtelephonetoavoid
interference.
• Whenwallmounting,usethe
twoeyeletholeslocatedonthe
rearpanel.Theholecentres
are102mmapart.
Burnside Telecom Limited
www.burnsidetelecom.com
quick start guide
T400 fixed cellular terminal
This quick start guide will help you to set up, switch on and begin using your T400 series
fixed cellular terminal unit. For further information on all features, please refer to the full
user guide available within the ‘Service & Support’ section at: www.burnsidetelecom.com
BURNSIDE
landline alternatives
BURNSIDE
www.burnsidetelecom.com
T400FX
WEE/AC0075UR/PRO
Madein China
EUONLY
RoHS
Fixed Cellular Terminal
328037 Input: 12VDC
REMOVE
BEFORE USE
Locking
screw
Battery
insulating
tab
Sliding
cover
IMEI 868259026362593
BURNSIDE
www.burnsidetelecom.com
T400FX
WEE/AC0075UR/PRO
Madein China
EUONLY
RoHS
Fixed Cellular Terminal
328037 Input: 12VDC
4 x AA
batteries
SIM
card
IMEI identity
label
The above illustrations are
of the T400LR UK version.
Battery care
Thesuppliedhighquality
PanasonicrechargeableNiMH
batteriesallowtheT400tofunction
whenthereismainspowerfailure.
Chargingofthebatteriesisfullyautomatic
andengineeredtoachievealongservicelife.
Thebatteriesaresuppliednearlyfullycharged.
Iftheterminalisnotgoingtobeusedforseveralmonths,
eitherremovethebatteriesorreplacetheinsulatingtab.
Performing a ring back test
Theringbacktesthelpstoconrm:thelinkwiththeconnectedphone,thecurrentring
cadenceandterminalstatus(forphonesthatsupportCaller Identity,alsoknownasCLI).
1 Liftthehandsetanddial*9#
2 Replacethehandset.Yourphoneshouldringuntilthehandsetislifted(orfor30
seconds).Ifyourphonehasacalleridentitydisplay,thestatusoftheT400terminalwill
beshown.
Making and receiving calls
• To make a call:Liftthehandsetandlistenforadialtone*.Dialtherequirednumberand
thenpress#toplacethecallimmediately.Ifyoudonotdial#,thecallwillbeplaced
afterthreesecondsafterthelastbuttonispressed.Youcanadjustthedelayperiod.
* If you hear a series of short tones, the terminal is waiting for you to enter a PIN code.
• To receive a call:Whenthephonerings,liftthehandsetandtakethecallinthenormal
way.Hanguptoterminatethecall.
©2018BurnsideTelecomLimited•Release1.0c
Batteries
Whenreplacingbatteries,alwaysreplaceallfour.Onlyusebatteries
recommendedbyBurnside,seewww.burnsidtelecom.com/support
PacksoffouroftheoriginalPanasonicBK200AABareavailablefromBurn-
sidesuppliers,partnumber228002.Anequivalentqualitybatterywidely
availablefromonlineretailersisthePanasonicEneloopBK-3MCCE.
Charger
Tomaintaintheoriginalhighlevelofsafety,onlyreplacethechargerwith
oneapprovedbyBurnside.Replacementchargersareavailablefrom
Burnsidesuppliers,kitnumber778017(includescharger,UKandEUplug).
Mounting template
PleaseusethistemplatetopositionscrewholeswhenwallmountingyourT400terminal.
Youarerecommendedtouse3mmx30pan-headscrews.
102mm

Making connections
Fitting the antenna
Fitthesuppliedantennangertightandrotatetheantennasothatitisvertical:
Indicators
Theamberandgreenindicators,
locatedonthetoppanel,provide
operationstatusinformationby
ashingonandoffinvarious
combinations.
Theredindicatorshowsthe
chargingstatus.
Seebelowfordetails.Each
completecirclebelowrepresents
twosecondsandtheshaded
portionsshowtheperiodthateach
indicatorison.
Power button pressed
Starting/searching
Waiting for PIN code
Waiting for PUK code
Calls possible, weak signal
Ready for call
Incoming call
Mobile call in progress
Landline call in progress (T400LR only)
Fault (such as no SIM card).
Emergency calls may still be possible
Charging batteries
Batteries charged
Battery fault
Inactive
Amberandgreen-operationstatus Red-chargingstatus
Antenna
Connect
the supplied
antenna here.
Telephone
Connect your telephone
here (UK connector
type shown). If your
phone has a different
connector, use an
adaptor (supplied in
some kits).
Landline
(T400LR models)
For connection to your
telephone wall outlet.
A cable is supplied in
some kits.
Power
Connect the supplied
charger and plug it
into a nearby mains
outlet. The red
indicator will flash
when the internal
batteries are being
charged.
Ifyouwallmounttheunit,leavetheantennapointingstraightout.
Thesuppliedantennaisefcientandsuitableformostinstallations.Ifyouhaveaproblem
withaweaksignal,trylocatingtheterminalwherethesignalisstronger,forexamplebya
window.
Forsomeinstallationsanoptionalremotelylocatedantenna,availablefromBurnside,may
produceimprovedresults.
Switching on and off
• To switch on:Pressandholdtheredbutton,labelled ,untiltheamberandgreen
indicatorsilluminate.Thecentregreenindicatorwillthenash.
• To switch off:Pressandholdtheredbutton,labelled ,untiltheallthreeindicators
illuminate,thenrelease.