Bush 8GB MP3 Player User manual

Bush 8GB MP3 Player with Display
MP3 Player Guide
How to use the player
Your music player only has a
few controls. The picture below
shows what each control does.
How do I use a
splitter cable?
The splitter cable
allows two people to listen to the
music player at the same time.
To use:
1. Plug one end of the splitter
cable into the music player.
2. Plug your headphones
into the other end of
the splitter cable.
Where to buy:
• Argos (click to see product)
• Amazon (click to see product)
How do I play music?
1. Slide the on/off switch to the
‘on’ position.
2. Plug in your headphones
and put them on.
3. Press the play/pause button
to start playback. The player
will remember the last song
you played and will start
playback from there.
4. To stop playback press the
play/pause button again
5. When you are finished
remember to switch the player
off again by sliding the on/off
switch to the ‘off’ position.
This player is available from Argos (click to see product)
Headphone
socket
(on top of
player)
Go to
previous
song
On/
off
Reduce
volume
of music
Go to
next
song
Play/
pause
Increase
volume
of music
Charging
socket
(on side
of player)
(continued overleaf)

How do I make the player
louder or quieter?
• To make your music louder
press the ‘Vol+’ button.
• To make your music quieter
press the ‘Vol-‘ button.
How do I find a
different song?
• To find a song press the ‘go
to next song’ button or ‘go to
previous song’ button.
• These buttons step forward
or backward through the list
of songs on your player.
• Keep pressing until you find
the song you want.
If you have a lot of songs on
your player it might help to
keep a printed list of the songs
it contains so it’s easier to find
a specific song.
How do I charge
the battery?
1. Plug small end of the
charging cable into the
music player.
2. Plug the large end of the
charging cable into the
charging plug.
3. Plug the player into a
power socket.
4. There is a small light on
the side of the player
that flashes when the
player is charging. When the
battery is fully charged the
light stays bright red.
5. When the player is charged
take the plug out of the wall
socket and pull the cable out
of the player. Your player
is ready to use.
How do I use the screen?
The screen on the music player
shows a range of information
including the name of the
song that is playing and the
singer/band. It can also show
lots of other information about
the player but in normal use
you shouldn’t have to use this.
If you would like to know more
please read the instruction
booklet that is in the player box.
Published April 2020 by Playlist for Life
Registered Charity: SC044072