C-RACER FG-KTM390ADV-O User manual

www.c-racer.com
INSTRUCTION
Model Product Code
ΚΤΜ 390/290 Adventure FG-KTM390ADV-O & W
CONTENTS
Fork Guard
FG-KTM390ADV-O
1. 2pcs Plastic Covers
2. 2pcs screws Μ6Χ20 (allen-round head-washer)
3. 4pcs screws Μ6Χ15 (allen-round head-washer)
4. 6pcs plastic washers 6Χ18
On these instructions the photographs and the
description refer to the left side, the same thing
applies for the right side.
Remove the front fender from the three side screws.
To remove it you have to rotate a little to pass between
the fork guards.
Install the covers and mount them with the new screws.
Do the same thing on the other side.
1.
1.
4.
3.
3.
2.
Page 1/2
FG-KTM390ADV-W

Page 2/2
Thank you for choosing one of our products.
If you want to complete the look of your motorcycle, it would be good to get the mudguard as well,
this way you will also protect from the mud and the dirt that goes to the fridge and the exhaust of the motorcycle.
Of course, this is optional.
For any further information please do not hesitate to contact us: Tel.: [phone] Email:
The product is for race use only
[e-mail]
INSTALLATION OF STICKERS
It is better to be placed by professionals.
If you think you have the skills, then follow the Instructions.
Clean the surface very well.
Spray with soap and water lightly all over the surface.
Remove the protective paper from the sticker and spray
this too and place it on the surface.
Adjust its position so that it is in the center and check its
position back and forth.
Once you make sure it is in the right place then start
pushing in the center so that it sticks only there.
Then with a soft spatula start to dispense the water
and bubbles to the outside.
You can heat it very lightly and carefully to help trapped
bubbles to go outside.
When all the water has left the sticker, press very well
the edges.
Wipe it very well and continue with the other pieces.
The result will be what you see in the photo.