C-RACER RH-KTM390-SB User manual

www.c-racer.com
INSTRUCTION
Model Product Code
ΚΤΜ 390/290 Adventure RH-KTM390-SB / BS
CONTENTS
Rear Hugger With Chain Guard
1. 1pcs Plastic Rear Hugger
2. 1pcs Alouminio Chain Guard
3. 1pcs screws Μ6Χ15 (allen-round head-washer)
4. 1pcs screws Μ6Χ10 (allen-round head-washer)
5. 1pcs screws Μ6Χ25 (allen-round head-washer)
6. 1pcs screws Μ5Χ15 (allen-round head-washer)
7. 1pcs screws Μ5Χ55 (allen-round head-washer)
8. 1pcs washers 6Χ12
9. 1pcs plastic washers 6Χ18
10.1pcs plastic washers 5Χ15
11.1pcs safety nuts Μ6
1. 2.
3.
4.
5.
9.
7.
10.
6.
8.
11.
Page 1/2
To place the new fender, you must remove the old one.
In the photos you may find the order and the place
of the screws you must remove.
First remove the cover from the front left footrest,
this helps to remove the front screw of the chain guard,
also remove the one at the back side.
After that remove the nut, (not easily seen).
(In the second photograph you will see the place of the
nut, only seen from the right side under
the shock ubsorber.)
Then remove the two main screws.
(In the third photograph there is only the right side,
on the left side there is the same screw)
After you have removed all the screws you must open
the back side of the chain guard which covers the base
on which it was mounted, to get it through from the chain.
Then rotate the fender and because it is elastic
you can carefully/easily remove it.

Page 1/2
For any further information please do not hesitate to contact us: Tel.: [phone] Email:
The product is for race use only
[e-mail]
Put the chain guard in place and pass the screws
(blueprint 7-10 forward & 5-8-9-11 for back)
without tightening them, just touch them to hold
the product in place.
Locally remove the protective film from fender
only where it will be screwed and place it on its position.
Then insert the screws (layout screws 3 & 4).
And just pass them.
Last you put the side screw that connects the fender
with chain protector.
All screws have an adjustment margin.
Align the fender and tighten the screws in the order
you put them. When it is finished, remove the protective
film as well from the fender.
With this product you can also put ON-Off tires,
there is enough gap.
Of course, it is not recommended for on-off use.
You can remove the fender and leave only the chain guard.
We wish you many and dry kilometers!
Thank you for choosing one of our products.