C-RACER NP-YT7-S User manual

www.c-racer.com
INSTRUCTION
Model Product Code
ΥΑΜΑΗΑ Tenere 700/T7 NP-YT7-S & NP-YT7-b
CONTENTS
CHAIN GUARD in SILVER & BLACK color
Page 1/3
For any further information please do not hesitate to contact us:
Tel.: [phone] Email:
The product is for race use only
[e-mail]
These are the parts you will find inside the package
Read the instructions before starting the installation.
Unscrew the 2 screws holding the guard on the front and
inside the scissor.
Then remove the screw that is visible from the outside, as shown
on the photograph.
1. 1pcs metal base
2. 2pcs screws M5X10 (allen-oval-washers)
3. 1pcs screw M5X20 (allen-oval-washer)
4. 1pcs adapter Φ12ΦΦ8Φ8mm

Page 2/3
Remove the metal base that the protector has on the
front part.
Screw it onto the new guard, but do not tighten the screws.
Slide the protector into place and screw it on back screw
without tightening it.
Be sure to place the adapter on the inside
of the protector as shown in the photo.
Screw the screws back at its old position with the same
screws and tighten them.

Page 3/3
This will be your final result. Enjoy your rides!
Finally tighten the screws from the top of the base and
the external.