Cambium Networks PTP 820 Series User manual

PTP 820C/820S PoE Injector Installation Instructions
phn-4013 001v000
1
PTP 820C/820S PoE Injector Installation Instructions
User Documentation
Installation and operation of the PTP 820 family of PTP links is described in the associated
Technical Descriptions and Installation Guides available for download from:
http://support.cambiumnetworks.com
Download and read the appropriate Technical Description and Installation Guide before deploying
the PoE Injector.
EU declaration of conformity
Hereby, Cambium Networks declares that the PoE Injector is an ancillary product that complies
with the essential requirements and other relevant provisions of Directive 1999/5/EC. The
declaration of conformity may be consulted at:
http://www.cambiumnetworks.com/support/ec-doc
Enquiries and support
http://support.cambiumnetworks.com/
PoE Injector Interfaces
Power-Over-Ethernet (PoE) Port
GbE Data Port supporting 10/100/1000Base-T
DC Power Port 2 ±(18-60)V
DC Power Port 1 ±(18-60)V
Grounding screw

PTP 820C/820S PoE Injector Installation Instructions
phn-4013 001v000
2
PoE Injector Grounding
1
On the right side of each PoE Injector, loosen the screw, plain washer, and serrated washer.
2
Place the cable lug (supplied with the PoE injector kit) between the plain and serrated washers.
3
Tighten the screw.
PoE Injector Cable Connection
1
Disassemble the relevant cap from the PoE Injector.
2
Connect the cable to the gland assembled with the PoE Injector.
3
Attach and tighten the gland to the PoE Injector.
4
Secure the cable to the gland using a tie wrap.
PoE Injector Wall Mount Installation
Required Tools
Metric offset wrench key wrench set
Hammer
Drilling Machine
Procedure
Mount the PoE Injector to a wall and tighten using two M6 bolts and anchors supplied with the PoE
Injector.

PTP 820C/820S PoE Injector Installation Instructions
phn-4013 001v000
3
1
Drill two 6mm diameter holes, with 100mm between the center of the holes.
2
Insert the anchors with the bolts.
3
Place the washers on the bolts.
4
Tighten the nuts.
5
Mount PoE Injector to Wall
Caution
For the warranty to be honored, you must install the unit in accordance with the
instructions above.