CAME ED3+ User manual
came.com/entrotec
ED3+
handset
instructions for use
ed3+ instructions
1. When called, the telephone will give a distinctive pulsing tone for up to 25 seconds and then stop. You have
approx. 30 seconds to answer the call from the start of the call tone. If the call is not answered within the call
period, then the system will reset to allow other visitors to make a call.
2. To answer the call remove the handset from the cradle and speak to the caller.(You have approx. 2 minutes to
speak to the caller and then the system will reset).
3. To let the caller gain access, press the lock release button and this will open the door for approximately 10
seconds.
4. When you have completed the call, replace the handset to reset the system.
5. If you do not wish to be disturbed or annoyed by nuisance calls, press the privacy switch (the Red LED will
illuminate to remind you that the handset is in privacy mode). When in this mode the call tone is muted until you
reset the switch by pressing it again. If you wish to terminate the privacy period press the privacy switch once,
the Red LED will extinguish and allow calls to be heard.
The door entry phone system is designed so that you have a limited time to answer a call and allow the caller access
or not. This is to save inconvenience to other users of the system.
general notes
instructions
privacy switch
ON
PRIVACY
ON PRIVACY
DOOR OPEN
Privacy Switch
Privacy on LED
Door Open LED
Lock Release Button
handset connection
1. All ED3+ handsets have a latching Privacy Switch. This should be set in the ‘Off’ position with the Red LED
extinguished to allow call tones to be heard.
2. All ED3+ handsets are tted with a Call Tone Volume adjustment (VOL). This maybe adjusted to suit level
required. Factory setting is full volume
3. On older systems (Vertex and old RDC’s) this may make the call tone fade. If this is the case check
for no DC on BZ and if 0v t PL5 link. If there is a DC voltage nd source and isolate before
tting link.
4. Terminal 8 must only be connected to an Extension Sounder, Flashing Beacon or other Aux. Equipment.
Installer Please Note
preferred colour coding for wiring handsets
WHITE/BLUE
BLUE/WHITE
WHITE/ORANGE
ORANGE/WHITE
WHITE/GREEN
GREEN/WHITE
WHITE/BROWN
DR
VT
0V
BZ
S2
S1
DS
EX
DS
S1
S2
BZ
0V
VT
DR
CW1308
1
2
3
4
5
6
7
8
PL5
CAME S.p.A.
Came cancelli automatici S.p.A.
is certied for Quality and Environment
UNI EN ISO 9001
UNI EN ISO 14001
BS OHSAS 18001
© 2022 - EN - ED3+INS0322
YOU MAY NOT EVEN PARTIALLY REPRODUCE THIS DOCUMENT
CAME RESERVES THE RIGHT TO MAKE ANY CHANGES TO THIS DOCUMENT AT ANY TIME
THE DATA AND INFORMATION SHOWN IN THIS CATALOGUE ARE SUBJECT TO CHANGE WITHOUT OBLIGATION TO GIVE PRIOR NOTICE BY CAME S.P.A, E&OE
CAME ENTROTEC
5 Ashwood Court
Oakbank
Livingston
EH53 0TL
Tel: 01506 886230
Support: 01506 886235
came.com/kms
Table of contents
Other CAME Handset manuals
