ed4+ instructions
1. When called, the telephone will give a distinctive pulsing tone for up to 25 seconds and then stop. You have
approx. 30 seconds to answer the call from the start of the call tone. If the call is not answered within the call
period, then the system will reset to allow other visitors to make a call.
2. To answer the call remove the handset from the cradle and speak to the caller.(You have approx. 2 minutes to
speak to the caller and then the system will reset).
3. To let the caller gain access, press the lock release button and this will open the door for approximately 10
seconds.
4. When you have completed the call, replace the handset to reset the system.
5. If you do not wish to be disturbed or annoyed by nuisance calls, press the privacy switch (the LED will illuminate
to remind you that the handset is in privacy mode). When in this mode the call tone is muted until you reset the
switch by pressing it again. There is also a built in timer that automatically resets the switch if you forget to do
so. This time period (up to 8 hours) is preset on installation but if you require a longer privacy period then press
the privacy switch twice to restart the timer. If you wish to terminate the privacy period press the privacy switch
once.
The door entry phone system is designed so that you have a limited time to answer a call and allow the caller access
or not. This is to save inconvenience to other users of the system.
general notes
instructions
privacy switch
ON
PRIVACY
ON PRIVACY
DOOR OPEN
Privacy Switch
Privacy on LED
Door Open LED
Lock Release Button
