Campania International 144533- 01 Series User manual

Revised February7,2018
COMPONENTSAND PARTSLIST
Pump KitPartsList
PK140 pump (1)
#9 rubberstopper(1)
20”length of1/2”BlackNon-kinktubing (1)*
2”length of5/8”cleartubing (1)*
2.8 oztubeofsilicone (1)
Hose clamps(1)
*Tubinghasbeenpreassembled
144533-XX01 BodenFountain
(2 pieces)
Toolsyou will need
Level
WaterFeature
13 lbs
Basin
81 lbs
Thisfountaintakescover
FTNCOV-SM
Fountainholds
approximately10
gallonsofwater

Revised February7,2018
ASSEMBLYINSTRUCTIONS
1.Makesureyou areassemblingyourfountainon alevelsurface
2.Assemblethe pumpkit
a. NOTE:All pumpscomewith1adapteralreadyinsertedintothepump and 2
adapterssecuredtothepowercord.
i. Thisfountainusesthelargestadapterprovided.
b.Usingahoseclamp, securethe 1/2"end ofthe tubingassemblytothe pump.
c.Applyabead ofsiliconetotheholeandslit atthe inside-topof thewhitestopper.
d.Fit cordintostopperapproximately6”-8”fromthe pump.
e.Applyabead ofsiliconetotheoutside edgesofthestopper.
3.Feed the pumpcordthroughtheholeinthe bottomof the basinandpress stopperinfirmly.
4.Applyafinalbead ofsilicone totheareawherethestopperandbasinmeet. Thisshould
createawatertight seal.
5.Slide the5/8”end ofthetubingassemblyontothecopperpipe extendingdownfromthe
bottomofthe waterfeature
6.Placethe waterfeatureontopof thebasinmakingsurethat the waterfeatureislevel.
a.Note–Wedgesmaybeusedifnecessarytolevelthe waterfeature.
7.Allowthe fountaintositfor24hoursbeforefillingwithwater.
a. Silicone musthavetimetocompletelyset beforethefountaincan beused.
WINTER CAREAND GENERALFOUNTAIN INSTRUCTIONS
-WINTERCARE-
Fountainbowls/topsandotherfountain components,which collectwater, shouldnot be left outside in the wintersince
anycomponent, which fillswith waterandfreezesmaycrack. Likewise componentssuch aspedestals,whichremain
in abasin, filled withwater,which thenfreezes, mayalso crackorcrumble. Ideally, therefore, a fountain should always
be storedindoors orina dryprotected place such asa covered porchawayfromthe elements. However,ifa fountain
must be left outside:
(1)Remove pump, rubberstoppers, drainpipes, finials,and othersmall componentsforstorage indoors. Note
that stoppers ordrainpipesare removed to allow drainage in the event wateraccumulatesin anybasin.
(2)Raisefountainbase fromground with wood stripsso that basewillnot freeze totheground surface.
(3)Coverorwrap thefountainwith burlap orotherabsorbent material(oldblanket ortowel)and then cover
securelywith plastic, making sure that waterwillnot accumulate in the basin orotherfountain component and freeze;
(4)Checkfountainperiodicallyto insure that plasticissecure and waterisnot accumulating in anyfountain
component.
-GENERALFOUNTAINTIPS-
Installfountainson alevelsurface. You willneeda properlygrounded 110-volt (AC only)GFCI protectedreceptacle
nearthe fountain foryourpump. All pumpsare submersibleandmust be completelyunderwaterto function properly.
Test all pumpsand adjust to full output priortoassembly. It isnot recommended that fountainsbe placed directlyon
grass ordirt. Position the channelopening at the baseofeach fountaintoward the electricaloutletto be used since the
pump cord willbethreaded through thisopening.
Formore Campaniaproduct information visit www.campaniainternational.com
144533-XX01 BodenFountain
(2 pieces)