Campania International GFRCFT-1107 User manual

Revised January, 2019
COMPONENTS AND PARTS LIST
Pump Kit Parts List
PK300 pump (1)
Wedges (4)
#5 Drain Stopper
* Tubing has been preassembled
GFRCFT-1107 Large Ribbed Cylinder Fountain
(2 pieces)
Tools you will need
Level
This fountain takes cover
FTNCOV-LG
Basin
19.75”W x 9.5”H
37lbs
Water Feature
19.5”W x 24”H
63 lbs
This fountain is compatible with a
#10 or #7 Refill Device
Fountain holds
approximately 10
gallons of water
SHOP NOW

Revised January, 2019
ASSEMBLY INSTRUCTIONS
1. Make sure you are assembling your fountain on a level surface
2. Assemble the pump kit
a. NOTE: Be sure to use the appropriate size adapter provided with the pump.
3. Place the pump inside the base of the fountain.
4. Feed the pump cord through the standpipe in the center of the basin, leaving enough cord
length inside of the basin to work with the pump sitting flat in the bottom of the bowl.
a. When the pump cord exits the base of the fountain, make sure it lines up with the
chancel that is cut into the bottom of the basin.
5. Slide the pump adapter into the provided tubing that is attached to the cylindrical water
feature.
6. Place the cylindrical water feature on top of the basin
a. Center the cylindrical water feature on top of the basin.
b. Note –Do not allow pump to run dry, as it will cause damage to the pump
WINTER CARE AND GENERAL FOUNTAIN INSTRUCTIONS
-W I N T E R C A R E -
Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since
any component, which fills with water and freezes may crack. Likewise components such as pedestals, which remain
in a basin, filled with water, which then freezes, may also crack or crumble. Ideally, therefore, a fountain should always
be stored indoors or in a dry protected place such as a covered porch away from the elements. However, if a fountain
must be left outside:
(1) Remove pump, rubber stoppers, drainpipes, finials, and other small components for storage indoors. Note
that stoppers or drainpipes are removed to allow drainage in the event water accumulates in any basin.
(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.
(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then cover
securely with plastic, making sure that water will not accumulate in the basin or other fountain component and
freeze.
(4) Check fountain periodically to insure that plastic is secure and water is not accumulating in any fountain
component.
-G E N E R A L F O U N T A I N T I P S -
Install fountains on a level surface. You will need a properly grounded 110-volt (AC only) GFCI protected
receptacle near the fountain for your pump. All pumps are submersible and must be completely underwater to function
properly. Test all pumps and adjust to full output prior to assembly. It is not recommended that fountains be placed
directly on grass or dirt. Position the channel opening at the base of each fountain toward the electrical outlet to be
used since the pump cord will be threaded through this opening.
For more Campania product information visit www.campaniainternational.com
GFRCFT-1107 Large Ribbed Cylinder Fountain
(2 pieces)
SHOP NOW