Canon Pixma Pro9500 Series User manual

1
www.booksmartstudio.com ©Booksmart Studio
Printing on the Fine Art Metal with the Canon Pro 9500 Printer
1. P Y P
Make sure you do NOT have any clogged nozzles.
Run the Nozzle Check before printing images. If
you run the test prints with clogged nozzles it will
throw o your color once they are unclogged.
(Please refer to your printer manual for additional
instructions)
2. L  F A M   
A. e metal requires to be loaded into the front path
of the Pro 9500.
B. Open the front tray
C. Its recommended to wear gloves at all times when
handling the Fine Art Metal.
D. Gently press the release button as shown in
picture #1 to release the front tray and tilt it forward.
E. Li the front tray until it stops as shown in picture
#2. e front feed button will light.
F. While keeping the front tray lied , tilt the front
tray forward to set it in Front Paper Feeding
Position as shown in picture #3.
G. Ensure that the Front Feed Button is lit.
H. Press the Rear Support Button to open the Rear
Support as shown in picture #4.
I. Pull out the Front Extension completely as shown
in picture #5
J. Press the right corner of the rear support to open
the rear support extension as shown in picture #6.
K. Press the Front Feed button. e printer starts
making operating noises and then the Power lamp
ashes for about 20 seconds.
L. Ensure that the Power lamp is lit and the Front
Feed button is ashing quickly.
M. Load the metal straight into the tray with the
print side facing up. Align the front edge of the paper
with the Sheets/Arrow mark on the Front Tray.
Align the right edge of the paper against the right
side of the front tray as shown in picture #7.
1.
2.
3.

www.booksmartstudio.com ©Booksmart Studio
2
4. 5.
6. 7.
3. S U P’ P S
A. Go to File / Print from the
top menu bar.
B. Set your Page Setup settings
appropriately.
C. Select Photoshop Manages
Color.
D. Select the prole you wish
to use.
E. Select the proper
rendering intent.
F. Click on Black Point
compensation.
G. Click Print.

4. Setting up the Canon Pro 9500 print driver:
A. Choose the correct printer.
B. Click on the tab that reads Layout, and go to
Quality & Media.
C. For the Media Type select Photo Paper Plus
Semi-Gloss.
D. For Paper Source select Front Tray.
E. For Print Mode select Printing a Top
Quality Photo.
F. Click Print.
. P H:
Avoid touching the surface of the metal. Hold by edges, and wear gloves if you are noticing ngerprints. Allow
the ink to have time to dry prior to stacking or handling.
. P P:
It is strongly recommended to apply a spray coating or laminate to the nal print. For spray coating use ClearJet®
Clear-Coating Type AFA Fine Art in either Gloss or Semi-Gloss.
3
www.booksmartstudio.com ©Booksmart Studio