6
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out
in this manual. All responsibility,for any eventual
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Installation
The cooker hood must be placed at a minimum distance of 65
cm from the cooking plane for electric cookers and 75cm for
gas or mixed cookers.
If theinstructionsforinstallationforthegashobspecifyagreater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Use
The cooker hood is provided with an upper air exit Bfor
discharging fumes externally for models including chimney
flue C( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.
Electrical connection
The electrical tension must correspond to the tension noted on
the label placed inside the cooker hood. Connect the electrical
plug, where provided, to the an easily accessible outlet in
conformity with local standards in force.
Where an electrical plug is not provided (for direct connection
to electrical network) place a standards approved bipolar
switch with an aperture distance of not less than 3mm
(accessible) from he contacts.
Operation
A B C D E F
General notes: Any function can be activated by
pressing softly the button under the symbol.
A. ON/OFF light button: By essing this button the
hood’s lights switch on.
B. ON/OFF motor button: By pressing this button the
extracting motor can be activated/stopped.
C.D.E.F. Speed regulator button: By progressing this
button the hood activates the selected extracting speed.
Funzione Timer: By pressing once again the Selectedspeed
button,the timer will last for 5 minutes. This function can be
applied to all 4 available speeds.
Grease filter saturation: After every 40 hours of use of the
hood, the button Bindicator shows byflashing slowly that
the grease filters need to be washed.
Charcoal filter saturation: After every 120 hours of use of
the hood, the button Bindicator by flasihing fast shows that
the charcoal filters need to be replaced.
INSTRUCTION ON MOUNTING AND USE
GB
Note: By pressing for at least 5 minutes the button Bwill
reset the filters saturation indicator.
Attention! This function should only be used after
performing the maintenance of the filters.
Automatic functioning through the heath sensor:
By pressing the button C D at the same time, the hood
starts the automatic functioning. The indicators of the 4 speeds
will flash in sequence . After more or less 30 seconds the
temperature sensor will start the motor choosing the right
extracting speed.The speed will change according to the heath
coming from the hob.
By pressing Bthe manual functioning can be restored.
Always clean the glass of the control for a correct
functioning.
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
Cleaning:
The cooker hood should be cleaned regularly internally and
externally.For cleaning use a cloth moistened with denatured
alcohol or neutral liquid detergents. Avoid abrasive detergents.
Warning: Failuretocarryoutthebasicstandardsofthecleaning
of the cooker hood and replacement of the filters may cause fire
risks. Therefore we recommend observing these instructions.
Anti-grease Filter – must be cleaned once a month, with non
abrasivedetergents, byhandorindishwasheronlowtemperature
and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version):
The active charcoal filters Fare not washable nor regenerative.
It should be changed every 6 months in normal use.
The active charcoal filters capture unpleasant cooking odours.
Replacing lightbulbs
Warning! Prior to touching the light bulbs ensure they are cooled
down.
Extract the lamp cover by levering it off with a small screwdriver
or similar tool.
Replace the damaged light bulb. Only use halogen bulbs of 20W
max (G4), making sure you do not touch them with your hands.
Close the lamp cover (it will snap shut).
