Car Solutions Q-ROI-ONE-5 Series User manual

Car-solutions.com
www.car-solutions.com
[email protected]

Do not modify, dismantle or unintended
operation this system outside Q-roi After Sales.
Damage occurred by unintended operation
may cause Q-roi After Sales service void.
Warning
Always wear seatbelt. When the vehicle is
suddenly stop can cause injury.
Remove dust, oil, and waste on the display.
Incidental damages (including, without
limitation, consequential damages due to the
use of this unit and the dead loss of business
profit, changes, loss of memory contents, etc)
will not be taken responsibility.
•Any function that requires your prolonged
attention should only be performed after
coming to a complete stop. Always
stop the vehicle in a safe location before
performing these functions. Failure to do so
may result in an accident.
The engine is off while the system operates for
long time, battery may be discharged.
This product is not a substitute for your
personal judgment. Any route suggested by
this navigation system may never supersede
any local traffic regulation. Do not follow route
suggestions if the navigation system instructs
you to perform an unsafe or illegal maneuver.
Warning
Warning / Precautions!
Car-solutions.com
www.car-solutions.com
[email protected]

1. General Spec
OS Android 4.2.2 (Jelly Bean)
CPU Telechips TCC8930 (1GHz Cortex A9 DualCore)
Display OEM LCD
Internal Memory DDR3 1GB RAM + 8GB eMMC
External Memory SDHC Slot Support (up to 64GB)
Function
A/V Input x 3,
Rear Cam Input x 1,
CAN(Controller Area Network) x 2,
Mic x 1,
External Speaker x 1 (mono),
External Audio Out x 1(Car Aux),
Output LVDS ( thru Video Interface),
RGB (thru Sub-Board)
Touch Type Resistive Touch
GPS SiRF
Resolution 800*480
USB USB 2.0 x 2
Input Voltage 12V
Temperature operating 0 C to 60 C
Storage -20 C to 60 C
Languages multi-languages
LCD
Size 10.2 inch(Diagonal)
Driver element a-Si TFT active matrix
Resolution 1280*480
Display mode Normally White, Transmissive
Surface
treatment Anti-Glare
Car-solutions.com
www.car-solutions.com
[email protected]

2. System Diagram
Application
Processor
DDR3
1GB
eMMC
Flash
Memory
8GB
Video
Decoder
Audio
Decoder
/Encoder
Image Scaler
LVDS
Transmitter
Microprocessor
With
2 CAN ports
CAN
Transceiver
CAN
Transceiver
USB HUB
TPA6112A2
Audio Amp.
Touch
Screen
Controller
LCD Display
Rear Camera
DVD Player
Other Composite signal
Speakers
Touch
Screen
Button CAN
data
Steering wheel
CAN data
USB Devices
- USB memory
- Hard Disc
- Wifi dongle
- BlueTooth dongle
- 3G / LTE dongle
- Other USB devices
Microphone
Car-solutions.com
www.car-solutions.com
[email protected]

3. Components
MODE switch cable* 1ea
(HARETC0001) REAR CAMERA cable * 1ea
(HARETC0002)
GPS Antenna * 1ea
(GPSANT0007)
Microphone cable * 1ea
(MICPHO0002)
WIFI dongle * 1ea
(ETCETC0110)
SD extension cable* 1ea
(HARETC0080)
Multi Cable* 1ea
(HARETC0108)
USB Cable* 1ea
(HARETC0111)
AV Cable* 1ea
(HAVCAB0026)
Power Cable* 1ea
(HPOWER0077)
10.2 Inch Monitor
(QCPASS0587) 3G dongle * 1ea
(ETCETC0155)
(Option)
B/T Board * 1ea
(QCPASS0481)
(Option)
Car-solutions.com
www.car-solutions.com
[email protected]

4. Exterior
①USB CABLE ⑨DIP S/W(I/F)
②MULTI CABLE ⑩OEM LCD CABLE
③SD EXTENTION CABLE
④AV CABLE
⑤POWER CABLE
⑥SPEAKER
⑦OTG(사용하지 않음)
⑧DIP S/W(MAIN)
①②③④⑤⑥
⑦
⑩⑧
⑨
Car-solutions.com
www.car-solutions.com
[email protected]

4. Original button usage
※Short Press : Switching Modes
(Q-ROI ↔ OEM)
<Memory Button #8>
<Voice button>
<I-DRIVE>
※ Long Press : Q-roi reset
※Short press Audio or Back or CD or Tel button to switch to OEM
※ Long Press : Switching Mode
(Q-ROI↔OEM)
Short Press : Go to Main Menu
Spin left/right : Move to up/down
in Menu
Push Left : Move to backward in Menu
Push Right : Move to forward in Menu
Push : Select / Confirm
1
1
※ Short Press
: Navigation Quick
button
※ First, Long press memory button #8 to set up switching Aux function.(Original function)
If you press memory button #8, Aux and modes will switch at the same time.
Car-solutions.com
www.car-solutions.com
[email protected]

5. Cautions before Installation
Ignition key should be taken off before starting installation, interface
power connection must be the last step in installation.
Power cable should be separated when connecting interface.
Should be no any electronic devices or magnetic pole around
installation place.
All steps of installation should be done by well-trained specialist.
Dismantling without manufacturer’s permission can not be
guaranteed, (No permission to break attached label on the board.)
Kindly check all parts are in the box, when receiving the product, if
anything missing, inform to the supplier or manufacturer.
Install GPS away from electromagnetic devices such as black boxes,
Hi-Pass and etc.
Advisable to Install GPS at the edge of dash board or a front window
or a rear window.
Install GPS antenna mounted on window or roof facing to Sky .
According to our sales policy, any problems caused by user’s
mistake, careless can not be guaranteed.
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
-4-
PIN Functions Dip S/W
1 NO USE
2 Select PDC Type 2, 3 - OFF : PDC is located in the right of the screen
2-ON, 3-OFF : PDC is located in the middle of the screen
3
4
NO USE
5
6
7
8 Reset factory settings
(not use for user)
OFF : DEFAULT
ON : Product factory reset
- I/F(Dip Switch ②)
-MAIN(Dip Switch ①)
PIN Functions Dip S/W
7 Rear camera ON : External Camera
OFF : OEM Camera
※Please make sure to disconnect the power cable of the interface and
reconnect the power cable again to apply the dip switch setting whenever
changing DIP switch. Otherwise, DIP switch setting will not be applied.
②
①
6.1 Dip Switch
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
※APPS→FACTORY SETTING
①Put Password and change program upgrade and set-up of
external device. (Only Installers are authorized)
※Please contact the manufacturer to get Password.
6.2 Setting Factory Menu
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
①
③
②
④
⑤
①CAR MODEL : No use
②DVD TYPE : Only for DVD connected to A/V
(Connect IR-AV1 to DVD to use DVD as touch Screen)
③CMMB SELECT : Select DTV model ( Only Chinese)
④SETTING
- GEAR CHECK TYPE : Detecting rear camera via either CAN or Rear Lamp.
- REAR CAM : Put “On” – External rear camera
Put “Off “ – OEM Camera
- SAFE MODE : Either Enable or Unable to watch Video while driving
- MODE SWITCH : NO use
⑤SAVE & EXIT : Save and Reboot
6.3 Setting Factory Menu
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
6.4 Installation Diagram
※ ※ Disconnect an OEM LCD cable from a monitor and connect it to QROI ONE
Monitor.
Speaker
Power Cable
AV Cable
SD Extension
Cable
Multi Cable
USB Cable
OEM LCD Cable
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
6.5 Connection of Power cable
POWER
Connect
Connect
< Behind the radio>
<OEM CABLE>
Connect
※ Disconnect the OEM cable
from CD Changer and then
connect to the dotted line
Remove the fiber optic
connector from the OEM plug
and re connect it to the male
end of the T-Harness.
SPEAKER
Connect
Car-solutions.com
www.car-solutions.com
[email protected]

This product has been tested and have passed under our strict
quality control. If the failure occurred due to the carelessness of
workmanship within one year after the purchase, we are
responsible to repair free of charge.
Please bring this warranty to dealer whom you purchased this
product from at the repair time. Should this warranty not
presented, repair charged will be on customer. Please keep this
warranty card.
Warranty
Product
name Q-ROI ONE BM 5S
Warranty
period
1 year Purchase
date
(yy/mm/dd)
Customer
Address
TEL
Name
Dealer
Address
Name
7. Quality Warranty
Car-solutions.com
www.car-solutions.com
[email protected]