Car Solutions QNAVI4-MAIN-V1.1 User manual

Car-solutions.com
www.car-solutions.com [email protected]

Do not modify, dismantle or unintended
operation this system outside Q-roi After Sales.
Damage occurred by unintended operation may
cause Q-roi After Sales service void.
Warning
Always wear seatbelt. When the vehicle is
suddenly stop can cause injury.
Remove dust, oil, and waste on the display.
Incidental damages (including, without limitation,
consequential damages due to the use of this
unit and the dead loss of business profit, changes,
loss of memory contents, etc) will not be taken
responsibility.
•Any function that requires your prolonged
attention should only be performed after coming
to a complete stop. Always
stop the vehicle in a safe location before
performing these functions. Failure to do so may
result in an accident.
The engine is off while the system operates for long t
ime, battery may be discharged.
This product is not a substitute for your
personal judgment. Any route suggested by this
navigation system may never supersede any local
traffic regulation. Do not follow route
suggestions if the navigation system instructs
you to perform an unsafe or illegal maneuver.
Warning
Warning / Precautions!
Car-solutions.com
www.car-solutions.com [email protected]

1. General Spec
OS Android 4.2.2 (Jelly Bean)
CPU Telechips TCC8930 (1GHz Cortex A9 DualCore)
Display OEM LCD
Internal Memory DDR3 1GB RAM + 8GB eMMC
External Memory SDHC Slot Support (up to 64GB)
Function
A/V Input x 3,
Rear Cam Input x 1,
CAN(Controller Area Network) x 2,
Mic x 1,
External Speaker x 1 (mono),
External Audio Out x 1(Car Aux),
Output LVDS ( thru Video Interface),
RGB (thru Sub-Board)
Touch Type Resistive Touch
GPS SiRF
Resolution 800*480
USB USB 2.0 x 5 (USB x 4, OTG USB x 1)
Input Voltage 12V
Temperature
operating 0 C to 60 C
Storage -20 C to 60 C
Languages multi-languages
Car-solutions.com
www.car-solutions.com
[email protected]

2. System Diagram
Application
Processor
DDR3
1GB
eMMC
Flash
Memory
8GB
Video
Decoder
Audio
Decoder
/Encoder
Image Scaler
LVDS
Transmitter
Microprocessor
With
2 CAN ports
CAN
Transceivr
CAN
Transceive
USB HUB
Audio Amp.
Touch
Screen
Controller
LCD Display
Rear Camera
DVD Player
Other Composite
Video Signal
Speakers
Touch
Screen
Button CAN
data
USB Devices
- USB memory
- Hard Disc
- Wifi dongle
- BlueTooth dongle
- 3G / LTE dongle
- Other USB
Accessories
Microphone
Car-solutions.com
www.car-solutions.com
[email protected]

3. Components
MODE switch cable* 1ea
(HARETC0001)
USB cable * 2ea
(HARETC0027)
REAR CAMERA cable * 1ea
(HARETC0002)
Speaker * 1ea
(SPEAKE0001)
AV/BT Cable * 1ea
(HAVCAB0020)
GPS Antenna * 1ea
(GPSANT0006) Multi cable * 1ea
(HARETC0068)
Power cable 16P * 1ea
(HPOWER0079)
Microphone cable * 1ea
(MICPHO0001)
WIFI dongle * 1ea(Option)
(ETCETC0110)
Sub-Board * 1ea
LVDS cable* 1ea
(HALVDSC0024)
LCD cable * 1ea
(HLVDSC0030)
Car-solutions.com
www.car-solutions.com [email protected]

4. OEM Buttons
Long Press : Q-ROI Mode
Short Press : OEM Mode
Car-solutions.com
www.car-solutions.com
[email protected]

5. Cautions before installation
Ignition key should be taken off before starting installation, interface
power connection must be the last step in installation.
Power cable should be separated when connecting interface.
Should be no any electronic devices or magnetic pole around installation
place.
All steps of installation should be done by well-trained specialist.
Dismantling without manufacturer’s permission can not be guaranteed,
(No permission to break attached label on the board.)
Kindly check all parts are in the box, when receiving the product, if
anything missing, inform to the supplier or manufacturer.
Install GPS away from electromagnetic devices such as black boxes, Hi-
Pass and etc.
Advisable to Install GPS at the edge of dash board or a front window or
a rear window.
Install GPS antenna mounted on window or roof facing to Sky .
Car-solutions.com
www.car-solutions.com [email protected]

6. Installation
※ APPS→FACTORY SETTING
①Put Password and change program upgrade and set-up of
external device. (Only Installers are authorized)
※ Please contact the manufacturer to get Password.
6.1 Factory Menu
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
①
③
②
④
⑤
①CAR MODEL : No use
②DVD TYPE : Only for DVD connected to A/V
(Connect IR-AV1 to DVD to use DVD as touch Screen)
③CMMB SELECT : Select DTV model (Only Chinese)
④SETTING
- GEAR CHECK TYPE : Detecting rear camera via either CAN or Rear Lamp.
- REAR CAM : Put “On” – External rear camera
Put “Off “ – OEM Camera
- SAFE MODE : Either Enable or Unable to watch Video while driving
- MODE SWITCH : NO use
⑤SAVE & EXIT : Save and Reboot
6.2 Factory Menu
Car-solutions.com
www.car-solutions.com
[email protected]

6. Installation
SD-card
REAR CAM
POWER
cable
GPS
SPK
SPK
REAR (12V OUT)
GND
TOGGLE
MIC
POWER cable
ACC
CAN1-H
AUX-GND
A OUT(R)
CAN2-H
GND
A OUT(L)
CAN1-L
CAN2-L
6.3 Installation Diagram
Car-solutions.com
www.car-solutions.com [email protected]

6. Installation
①Pull away a OEM cable
behind the monitor.
②Connect the OEM cable to the
supplied female power cable.
③Connect the opposite side of supplied power
cable to the port where the OEM cable used to be
connected.
6.4 Plug & Play Power cable
Car-solutions.com
www.car-solutions.com [email protected]

6. Installation
①Pull away a green color OEM
LCD cable marked in red circle.
②Connect OEM LCD cable to a
supplied sub-board.
③Connect a supplied LCD cable to the sub-board and connect brown
connector to the port in monitor where the OEM LCD cable was
connected.
6.5 Plug & Play LCD Cable
Car-solutions.com
www.car-solutions.com [email protected]