Cardioline ar2100view User manual

ar2100view quick reference guide
The package contains
1) ar2100view
7) Anti-dust bag
1 –Preparing the device
•To open the printer door (A), put
your fingertips in the opening Band
turn the door upwards;
•Put a paper pack (6) in the side
opening (B); the black mark must be
on the upper margin;
•Slip the paper under the two red
slide guides (C) and close the door;
•Connect the patient cable (5) to the
patient cable connector on the right
side of the device (D) and screw it in
securely;
•Connect the power cord (2) to the
plug on the back of the device (E)
and the mains supply network;
•Power on the device pressing the Power On button on the back of the device (F) for a few
seconds.
•Date and time settings: press Menu
•Use the arrows to scroll the Settings menu and press OK;
•Select General, press OK, select Date\Time, press OK;
•Use the arrows to scroll; enter data using the keypad;
•Press OK to confirm.
B
A C
C D
E F
6) Pack of ECG paper 8) ECG measuring
ruler
4) Disposable electrodes
ECG, tab, 100pcs
3) Alligator clip adapter
10pz
2) Power cord
5) Patient cable

•Patient data may be entered before recording begins;
•To enter data, press ID, then press OK;
•Use keypad to enter required data; use the arrows to scroll the fields;
•When finished, press ESC. The entered data will appear on printouts.
4 –Printing and display settings
Automatic
Manual
Other: See the
user manual
Display
settings
Printing settings
•The screen displays ECG waveform
settings for video presentation
(vertical bar) and printout (horizontal
bar).
Settings Display Printing
Sweep speed +
Channels +
Gain +
•To set the printing format and the
video display for different operation
modes, press the buttons as shown
in the chart.
Note: For further settings and operation modes,
please see the user manual.
3 –Entering patient data
Via Fratelli Bronzetti, 8 - 20129 Milan (Italy)
Tel. [phone] Email: [email protected] - www.cardioline.it
Cardioline S.p.A.
•Press to switch from
Automatic mode to Manual mode
and vice versa; make sure the
corresponding icon shows on the
bottom right part of the screen; to
start recording an ECG press the AUTO or MANUAL button according
to the selected operating mode. To stop manual printing press STOP:
2 –Selecting Manual or Automatic mode