Carrier Aura User manual

ROOM AIR CONDITIONER
SAFETY PRECAUTIONS
Precautions during installation
Precautions during installation
Please observe the following safety precautions when using
the air conditioner.
Please ask your sales agent or qualified technician for
assistance on the installation of your unit. Water leakage,
short circuit or fire may occur if you install the unit yourself.
Please use earth line.
Do not place the earth line near water or gas pipes,
lightning-conductor, or the earth line telephone. Improper
grounding could cause electric shock.
A circuit breaker should be installed depending on the
mounting site of the unit to avoid electric shock.
Use a minimum breaker size of 20A.
1. Ensure that at least two able bodied persons are present to lift the air conditioning unit from the box to minimize
risk of injury or accident. Remove the strap and lift from the carton box. You may also tear the box but please
ensure you have proper tools like scissors or cutter. Take extra care to avoid damaging the unit.
2. Upon opening the box, you will find a plastic package containing this manual and accessories for
your air conditioning unit. Please refer to the checklist below for accessories included in your unit.
Failure or negligence in observing these safety precautions
could cause fire, electrical shock or personal injury.
OWNER’S MANUAL
This product is accesible to the general public.
The appliance shall be installed in accordance
with the national wiring regulation.
Do not install near location where there is
flammable gas. The unit may catch fire when
flammable gas leaked around it.
This appliance can be use by children age 8 years
and above and person with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning on the proper use of
appliance and understand the hazards involved.
This appliance is not intended to use by a person
(including children) with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning on the proper use of
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
Contact the authorized service technicain for repair and
maintenance of the unit.
Contact the authorized installer for unit installation.
Damaged supply cord must be replaced by the
manufacturing or qualified servicing agent.

Checklist of Items
C
Sealing Gasket
1 pc.
DScrew Truss Head
4 pcs.
E
Nut: Hex 1/4
4 pcs.
FWasher: Lock 1 & 4
4 pcs.
G
Screws for the
Mounting Bracket
6 pcs.
HMounting Bracket
2 pcs.
IScrews for the
Drain Pan
2 pcs.
J
Drain Pan
1 pc.
K
AAA Battery
2 pcs.
Carrier Aura Inverter
1.0 hp / 1.5 hp
(with LCD Remote)
3. Please ensure that the following tools are available prior and during installation of the unit:
4. Work on a smooth, clean and sturdy surface that is free of clutter.
A. 1 Phillips Screwdriver (+)
B. Ruler or Measuring tape
BRemote Control 1 pc.
ON/OFF
ONTIM ER
SLEE
P
SWING
OFFTIMER
CYCLE
TURBO
BAL
LOWER
RUN-H
CLOC
K
MODE
EC
O
FA
N
SPEE
D
AOwner’s Manual1 pc.

                                     
P
*The hole / opening on the wall should have at least 5mm of
allowance on the 3 sides (left, right and top)to allow the air
TYPE CAPACITY WIDTH (mm)HEIGHT (mm)
CARRIER
AURA INVERTER
1.0 hp
560
375
1.5 hp
560
375
conditioning
coating. Also, allowing this extra clearance ensures that the
outer wrapper shall remain square and not distorted.

rectangular
                            
                         
                          
                          
          
                 
                            
                                
             
                              
                             
                        
                                  
                     
                        
                           
                        
                             
              
 
                         
           
 
                 
        
 
                         
                    
 
                           
                     
                               
                            
                     
             
 
                        
                            
                           
           
               
                        
100 mm
                  


CODE DESCRIPTION REQUIRED ACTION
Control Panel
Code E1..E2..Ez System Errors
Contact yourservice center
P1..P2..Pz Protection Errors
EEco Mode Activated --
tTurbo Mode Activated --
SL Sleep Mode Activated
--
CY Cycle Mode Activated
--
rd Run-hour Deactivated Activate run-hourfeature.
rA Run-hour Activated --

press the up (+) or
down (-) button to adjust to the desired number of hours.
and

REMOTE CONTROL OPERATION
1. POWER ON / OFF
Press ON/OFF BUTTON toturn on the air conditioner
ON/OFF
or vice versa. When turned on, it will operate according
to the setting shown on the Remote unit.
2. FAN
Press the Button to select the fan speed
;
SPEED
FAN
low, med, high or auto
3. TEMPERATURE SETTING
Press (^) or (v) to set the temperature within the
range of 18-30º C.
4. OPERATING MODE
Press the MODE button to select the operating
MODE
mode (Fan, Cool, Dry)
5. AIR SWING
Press the SWING button toturn on/off the
SWING
air swing motor and the LCD will display SW.
6. ECONO (ENERGY SAVING)
Press the
ECO
ECONO button whilethe unit is used in
COOL mode for the energy saving feature to be activated.
The LCD on remote will show ECO.
7. TURBO
Press the TURBO button whilethe unit is used in
TURBO
COOL mode for the turbo feature to be activated. The
LCD on remote will show the TURBO icon (for 30 minutes
only). The indoor fan will run at high fan speed for a
while and compressor at maximum frequency. The
turbo feature will be terminated when
• The compressor is cut-off (change from run to stop). OR,
• The turbo feature has operated continuously for 30 minutes.
8. SLEEP
SLEEP
9. CYCLE (Energy Saving)
The air conditioner can be programmed to TURN
ON/OFF in a cycle manner. Press CYCLE button while
the power status is on, the unit will be turned on and off
at 30 minutes intervals.
10. CLOCK
To set the clock on the Remote unit:
• Press CLOCK button and time display will blink.
• Press to set hour.
(v)
• Press to set minutes.
(v)
• Press CLOCK button again.
The time display will stop blinking.
Press SLEEP button while the unit is in COOL mode.
When this feature is activated, the temperature setting shall be
automatically raised by 1 C after ONE HOUR. At the 2nd hour,
the temperature setting will again be automatically raised up by
1 C. The change of temperature is up to the 2nd hour only.
The temperature rise will not be seen on the LED Screen.
When this feature is activated, the letter “SL” is shown.
To cancel this function press SLEEP button again.
If the temperature setting is changed before the controlled
temperature is raised up, it will be raised up from
the last setting.
If the power supply fails the unit is turned off or the
operating mode is changed, the sleep feature will
be deactivated.

11. LOUVER
Not available in this model
12. ON TIMER
The air conditioner can be programmed to to turn on
in advance.
15. RUN HOUR TARGET SETTING
To change the target setting, press the
16. CHECKING BALANCE
Press button while the Run Hour feature is active
and the LED display will show the remaining hours
for 5 seconds. If the counter is below 100 hours, the 2-digit
LED will display the remaining hours for 5 seconds. If the
remaining value is above 100 hours, the dot after the first
digit will be lit and the value shown is to be multiplied
by 10. Please refer to example above.
Note:
If the setting is equal to vvor above 100 hours, the dot after
the 1st digit will be lit. The value shown has to be
multiplied by 10.
Examples:
If unit displays 2.4 (with decimal point lit), this means
24 x 10 = 24 hours.
If unit displays 10 (without decimal point lit), this means
10 hours.
button. As soon as it displays the last setting, press
the button. The target can be set in a
range of 10-990 hours (10 hours each per up /
down press). When the desired value is reached,
press button again to confirm the new target
setting. The Run Hour counter will reset and the
display will go back to normal. If the button is not
pressed to confirm within 10 seconds, the display
will go back to its regular setting automatically and
the target set value will be discarded.
or
• Press ON TIMER, and start-time display will blink.
ON TIMER
• Press ON TIMER button again and start-time
display will stop blinking.
To cancel this function, press ON TIMER
butoon again. The dot after the 2nd on the
LED will show the status of the timer setting.
ON TIMER
• Press to set hour.
to set minutes.
(v)
• Press (v)
13. OFF TIMER
The air conditioner can be programmed to
to turn off in advance.
• Press OFF TIMER, the symbol and
start-time display will blink.
OFF TIMER
BAL
Notes: if the button is pressed while Run Hour
operation is deactivated, “rd” will be shown at the 2-digit
LED for 5 seconds.
If the counter has reached zero balance, the dot after the
1st digit will blink continuously as the alarm and the unit
will be locked out. You would need to reset the run hour
target setting before you can use the aircon unit again.
BAL
OFF TIMER
• Press OFF TIMER button again,
and stop-time display will stop blinking.
To cancel this function, press ON TIMER
butoon again. The dot after the 2nd on the
LED will show the status of the timer setting.
• Press to set hour.
to set minutes.
(v)
• Press and hold button from the remote
handset for 3 seconds, the LED screen will show
‘ rd ’ which stands for Run Hour deactivated.
The screen will also show the previous target setting.
RUN -H
RUN -H
RUN -H
RUN -H
• To activate, wait for the display to go back to normal
The setting will be confirmed immediately.
Do the same thing to deactivate the Run Hour Function,
In case you do not want to use it.
then press button again for 3 seconds until
the ‘ rd ’ re-appears. Immediately press mode from
the unit display board, wait until the unit display ‘ rA ’
RUN -H
• Press (v)
14. RUN HOUR OPERATION ACTIVATION / DEACTIVATION
The user can activate or deactivate the
Run Hour target operation. When it is activated and
the unit is on, the unit will run based on the balance
number of hours from the target that was set. When
the set hour target is reached, the dot after the 1st digit
will blink continuously which will serve as an alarm.

When servicing the air conditioner, be sure the unit is unplugged.
Do not use gasoline, thinner, liquid insecticide or any chemicals
on the air conditioner. Use of these may damage the paint and
plastic parts. Never attempt to clean the unit by pouring water
directly on it as this will cause deterioration of the electrical
insulation.

I understand that my continued use of this, and other CCAC products, and availment of CCAC's services will constitute my acceptance
and consent to the terms and conditions of CCAC's Privacy Notice.
I consent to the collection, recording, organization, storage, updating or modication, retrieval, consultation, use, consolidation, blocking, erasure
or destruction by Concepcion-Carrier Air Conditioning Company (CCAC) of my data below for the purposes identied in its Data Privacy Notice,
published in its website (www.carrier.com.ph), which is deemed incorporated into this Warranty Card.
RC14213150 Rev1