Carrier DE 60HIDU230X5 User manual

HIGH STATIC PRESSURE DUCT TYPE AIR CONDITIONER
Installation Manual
High Static Pressure Duct Type
IMPORTANT NOTE:
Read this manual carefully before
installing or operating your new air
conditioning unit. Make sure to save
this manual for future reference.
DE/DM 60HIDU230X5 PC: 22023011003834
DE/DM 60HOS18230E5 PC:22023016002111

Accessories .................................................... 04
Indoor Unit Parts ........................................ 10
Indoor Unit Installation Instructions ....... 11
Safety Precautions ..................................... 06
Outdoor Unit Installation ......................... 17
Outdoor Unit Installation Instructions ...... 17
Outdoor Unit Types and Specifications .... 18
Notes on Drilling Hole in Wall .................... 20
Drainpipe Installation ............................... 21
Table of Contents
Installation Manual
Indoor Unit Installation ........................... 10
Installation Overview ............................... 09
1
2
5
3
4
6

Page 3 
Refrigerant Piping Connection....................... 23
Notes on Pipe Length and Elevation ............... 23
Refrigerant Piping Connection Instructions .... 25
Wiring................................................. 27
Outdoor Unit Wiring ................... 27
Indoor Unit Wiring ...................... 28
Power Specifications ................... 30
Air Evacuation ................................................. 32
Evacuation Instructions ................................. 32
Note on Adding Refrigerant ........................
........................
33
Test Run....................................................................................... 34
35
MC MC
7
8
9
10
11
L N
European Disposal Guidelines

Page 4 
Accessories 1
The air conditioning system comes with the following accessories. Use all of the installation parts
and accessories to install the air conditioner. Improper installation may result in water leakage,
electrical shock and fire, or cause the equipment to fail.
QUANTITY
SHAPENAME
Soundproof / insulation sheath 2
1
1
1
1
1
Tubing & Fittings
Others
Installation manual
Transfer connector (some models)
(Φ9.52-Φ9.52)/(Φ0.375in-Φ0.375in)
(Packed with the indoor unit )
NOTE: Pipe size may dier from
appliance to appliance. To meet
dierent pipe size requirements,
sometimes the pipe connections
need a transfer connector installed
on the outdoor unit.(some models)
Component of display control
unit (some models)
1
Owner‘s manual
Drain joint (some models)
Seal ring (some models)
Drainpipe Fittings
(for cooling & heating)
1
1
EMC Magnetic
Ring (some
models)
Magnetic ring (wrap the electric
wires S1 & S2 ( P & Q & E ) around
the magnetic ring twice)
Magnetic ring
(Hitch on the connective cable
between the indoor unit and
outdoor unit after installation.)
S1&S2(P&Q&E)

Optional accessories
There are two types of remote controls: wired and wireless.
Select a remote controller based on customer preferences and requirements and install in an
appropriate place.
Refer to catalogues and technical literature for guidance on selecting a suitable remote controller.
•
Page 5 
QUANTITY
SHAPENAME
1
1
2
2
1
1
1
1
Remote controller manual
Remote controller
(on some models)
Frame(on some models)
Alkaline dry batteries (AM4)
Wire controller
Remote controller &
Its Frame(Match with
remote controller )
Wire controller & Its
Frame(Match with
wire controller )
Mounting screw(ST2.9×10-C-H)
Owner‘s manual of wire controller
Wire controller installation manual

Page 6 
Safety Precautions 2
Read Safety Precautions Before Installation
Incorrect installation due to ignoring instructions can cause serious damage or injury.
The seriousness of potential damage or injuries is classified as either a WARNING or CAUTION.
WARNING
• Install according to this installation instructions strictly.
• Carefully read the Safety Precautions before installation.
When installing the unit in a small room, take measures against to keep refrigerant
concentration from exceeding allowable safety limits in the event of refrigerant leakage. Contact
the place of purchase for more information. Excessive refrigerant in a closed ambient can lead to
oxygen deciency.
Use the attached accessories parts and specied parts for installation.
• Install at a strong and firm location which is able to withstand the set' s weight.
If the strength is not enough or installation is not properly done, the set will drop to cause injury.
• Before obtaining access to terminals, all supply circuits must be disconnected.
• The appliance must be positioned so that the plug is accessible.
• The enclosure of the appliance shall be marked by word, or by symbols, with the
direction of the fluid flow.
• For electrical work, follow the local national wiring standard, regulation and this
installation instructions. An independent circuit and single outlet must be used.
If electrical circuit capacity is not enough or defect in electrical work, it will cause electrical shock re.
• Use the specified cable and connect tightly and clamp the cable so that no external
force will be acted on the terminal.
If connection or xing is not perfect, it will cause heat-up or re at the connection.
• Wiring routing must be properly arranged so that control board cover is fixed properly.
If control board cover is not xed perfectly, it will cause heat-up at connection point of terminal,
re or electrical shock.
Failure to observe a warning may result in death. The appliance must be installed in
accordance with national regulations.
Failure to observe a caution may result in injury or equipment damage.
WARNING
CAUTION
After completing the installation, make sure that the unit operates properly during the start-up
operation. Please instruct the customer on how to operate the unit and keep it maintained.Also, inform
customers that they should store this installation manual along with the owner's manual for future
reference.

Page 7 
• If the supply cord is damaged, it must be replaced by the manufacture or its service
agent or similarly qualifued person in order to avoid a hazard.
• When carrying out piping connection, take care not to let air substances go into
refrigeration cycle.
Otherwise, it will cause lower capacity, abnormal high pressure in the refrigeration cycle, explosion
and injury.
• Do not modify the length of the power supply cord or use of extension cord, and do
not share the single outlet with other electrical appliances.
Otherwise, it will cause re or electrical shock.
• If the refrigerant leaks during installation, ventilate the area immediately.
• The temperature of refrigerant circuit will be high, please keep the interconnection
cable away from the copper tube.
Toxic gas may be produced if the refrigerant leaks into the room and comes into contact with a
source of re, such as a fan heater, stove or cooker.
• The appliance shall be installed in accordance with national wiring regulations.
• An all-pole disconnection device which has at least 3mm clearances in all poles , and
have a leakage current that may exceed 10mA, the residual current device (RCD)
having a rated residual operating current not exceeding 30mA, and disconnection
must be incorporated in the fixed wiring in accordance with the wiring rules.
In certain functional environments, such as kitchens, server rooms, etc., the use of specially
designed air-conditioning units is highly recommended.
• Only trained and certified technicians should install, repair and service this air
conditioning unit.
Improper installation may result in electrical shock, short circuit, leaks, fire or other damage to
the equipment and personal property.
• Strictly follow the installation instructions set forth in this manual.
Before you install the unit, consider strong winds, typhoons and earthquakes that might aect
your unit and locate it accordingly. Failure to do so could cause the equipment to fail.
After installation, ensure there are no refrigerant leaks and that the unit is operating properly.
Refrigerant is both toxic and flammable and poses a serious health and safety risk.
This appliance is not intended for use by persons(including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
The appliance (indoor units) shall not be installed in the laundry.

Page 8 
CAUTION
Note about Fluorinated Gasses
1. This air-conditioning unit contains fluorinated gasses. For specific information on the type of gas
and the amount, please refer to the relevant label on the unit itself.
2. Installation, service, maintenance and repair of this unit must be performed by a certified
technician.
3. Product uninstallation and recycling must be performed by a certified technician.
4. If the system has a leak-detection system installed, it must be checked for leaks at least every 12
months.
5.
When the unit is checked for leaks, proper record-keeping of all checks is strongly recommended.
• Ground the air conditioner.
Do not connect the ground wire to gas or water pipes, lightning rod or a telephone ground
wire. Incomplete grounding may result in electric shocks.
• Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in electric shocks.
• Connect the outdoor unit wires , then connect the indoor unit wires.
You are not allow to connect the air conditioner with the power source until wiring and piping
the air conditioner is done.
• While following the instructions in this installation manual, install drain piping in
order to ensure proper drainage and insulate piping in order to prevent condensation.
Improper drain piping may result in water leakage and property damage.
• Install the indoor and outdoor units, power supply wiring and connecting wires at
least 1 meter away from televisions or radios in order to prevent image interference
or noise.
Depending on the radio waves, a distance of 1 meter may not be sucient enough to eliminate
the noise.

Page 9 
Installation Overview 3
Installation
Overview
L N
123
4
5
MC MC
6
7
Install the indoor unit
(Page 10)
INSTALLATION ORDER
Install the outdoor unit
(Page 17) Install the drainpipe (Page 21)
Evacuate the refrigeration system
(Page 32) Connect the wires (Page 27) Connect the refrigerant pipes (Page 23)
Perform a test run
(Page 34)

Page 10 
Indoor Unit Installation 4
Indoor Unit
Installation
Indoor Unit Parts
WARNING
•Securely install the indoor unit on a structure
that can sustain its weight. If the structure is
too weak, the unit may fall causing personal
injury, unit and property damage, or even
death
• DO NOT install the indoor unit in a bathroom
or laundry room as excessive moisture can
short the unit and corrode the wiring.
Safety Precautions
Fig. 4.1
Air outlet Air inlet
Drain hose
Refrigerant connecting pipe
Electric control cabinet
Air filter(inside air-in grill)(optional)
Heat exchanger
CAUTION
DO NOT install the unit in the following locations:
Where oil drilling or fracking is taking place
Coastal areas with high salt content in the air
Areas with caustic gases in the air, such
as near hot springs
Areas with power fluctuations, such as
factories
Enclosed spaces, such as cabinets
Areas with strong electromagnetic waves
Areas that store flammable materials or gas
Rooms with high humidity, such as
bathrooms or laundry rooms
CAUTION
•Install the indoor and outdoor units, cables
and wires at least 1m (3.2’) from televisions
or radios to prevent static or image
distortion. Depending on the appliances, a
1m (3.2’) distance may not be sufficient.
•If the indoor unit is installed on a metal
part of the building, it must be grounded.
Install the indoor unit at least 2.4m(7.87’)
from the oor.
•
At delivery, the package should be checked and any damage should be reported immediately to the
carrier claims agent.
When handling the unit, take into account the following:
Fragile, handle the unit with care.
Keep the unit upright in order to avoid compressor damage.
Choose on before hand the path along which the unit is to be brought in.
Move this unit as originally package as possible.
When lifting the unit , always use protectors to prevent belt damage and pay attention to the
position of the unit’s centre of gravity.