Caso C5 User manual

1
Operating manual
Designer glass scales C5
Item no. 13280

1.1IMPORTANT SAFEGUARDS
►Read all instructions
►The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.
►Do not use outdoors
►Do not place on or near a hot gas or electric burner, or in a heated
oven.
►Do not use appliance for other than intended use.
►Intended for household use only
►SAVE THESE INSTRUCTIONS.
1.2 General
Please read the information contained herein so that you can become familiar with
your device quickly and take advantage of the full scope of its functions.
Your food processor will serve you for many years if you handle it and care for it
properly.
We wish you a lot of pleasure in using it!
1.3 Information on this manual
These Operating Instructions are a component of the food processor (referred to
hereafter as the Device) and provide you with important information for the initial
commissioning, safety, intended use and care of the device.
The Operating Instructions must be available at all times at the device. This
Operating Manual must be read and applied by every person who is instructed to
work with the device:
•Commissioning, Operation, Troubleshooting and/or Cleaning
Keep the Operating Manual in a safe place and pass it on to the subsequent owner
along with the device.
1.4 Warning notices
The following warning notices are used in the Operating Manual
concerned here.
DANGER

A warning notice of this level of danger indicates a
potentially dangerous situation.
If the dangerous situation is not avoided, this can lead to death
or serious injuries.
►Observe the instructions in this warning notice in order to
avoid the danger of death or serious personal injuries.
WARNING
A warning notice of this level of danger indicates a
possible dangerous situation.
If the dangerous situation is not avoided, this can lead to
serious injuries.
►Observe the instructions in this warning notice in order to
avoid the personal injuries.
ATTENTION
A warning notice of this level of danger indicates a
possible dangerous situation.
If the dangerous situation is not avoided, this can lead to slight
or moderate injuries.
►Observe the instructions in this warning notice in order to
avoid the personal injuries.
PLEASE NOTE
A notice of this kind indicates additional information, which will
simplify the handling of the machine.
1.5 Limitation of liability
All the technical information, data and notices with regard to the installation,
operation and care are completely up-to-date at the time of printing and are compiled
to the best of our knowledge and belief, taking our past experience and findings into
consideration.
No claims can be derived from the information provided, the illustrations or
descriptions in this manual.
The manufacturer does not assume any liability for damages arising as a result of the
following:
•Non-observance of the manual
•Uses for non-intended purposes
•Improper repairs
•Technical alterations

•Use of unauthorized spare parts
All translations are carried out to the best of our knowledge. We do not assume any
liability for translation errors, not even if the translation was carried out by us or on
our instructions. The original German text remains solely binding.
1.6 Copyright protection
This document is copyright protected.
CASO Design USA LLC reserves all the rights, including those for photomechanical
reproduction, duplication and distribution using special processes (e.g. data
processing, data carriers, data networks), even partially.
Subject to content and technical changes.
2 Safety
This chapter provides you with important safety notices when handling the device.
The device corresponds with the required safety regulations. Improper use can result
in personal or property damages.
2.1 Intended use
This device is only intended for use in households in enclosed spaces for weighing
food. Uses for a different purpose or for a purpose which exceeds this description are
considered incompatible with the intended or designated use.
Warning
Danger due to unintended use!
Dangers can emanate from the device if it is used for an
unintended use and/or a different kind of use.
►Use the device exclusively for its intended use.
►Observe the procedural methods described in this Operating
Manual.
Claims of all kinds due to damages resulting from unintended uses are excluded.
The User bears the sole risk.
2.2 General Safety information
Please note
Please observe the following general safety notices with
regard to the safe handling of the device.
►Examine the device for any visible external damages prior to
using it. Never put a damaged device into operation.
►Persons, who are not able to operate the device because of
any physical, mental or motor disabilities may only use the

device under the supervision or under the instructions of a
responsible person.
►Do not permit children to use the device, unless they are
supervised.
►Only customer service departments authorized by the
manufacturer may carry out repairs on the device during the
guarantee period, as otherwise the guarantee entitlements
will be null and void in the event of any subsequent
damages.
►Defective components must always be replaced with original
replacement parts. Only such parts will guarantee that the
safety requirements are fulfilled.
►Do not drop it or jump on the scale, otherwise the scale is
easy to damage.
3 Commissioning
This chapter provides you with important safety notices during the initial
commissioning of the device. Observe the following notices to avoid dangers and
damages:
3.1 Safety information
Warning
Personal and property damages can occur during
commissioning of the device!
Observe the following safety notices to avoid such dangers:
►Packaging materials may not be used for playing. There is a
danger of suffocation.
3.2 Delivery scope and transport inspection
As a rule, the Designer multi grater is delivered with the following components:
•Designer glass scales C5
•Operating Instructions
Please note
►Examine the shipment for its completeness and for any
visible damages.

►Immediately notify the carrier, the insurance and the supplier
about any incomplete shipment or damages as a result of
inadequate packaging or due to transportation.
3.3 Unpacking
•Remove the device out of the carton and remove the packaging material.
3.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces
the quantities of accumulated waste. Take any packaging materials that are no
longer required to “Green Dot” recycling collection points for disposal.
Please note
►If possible, keep the original packaging for the device for the
duration of the guarantee period of the device, in order that
the device can be re-packaged properly in the event of a
guarantee claim.
3.5 Setup
3.5.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup
location must fulfil the following prerequisites:
•The device must be set up on a firm, flat and horizontal surface with sufficient load-
bearing capacity for the scale and the maximum weight of the food that should be
weighed.
•Choose the setup location in such a way that children cannot reach the device.
•Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
3.6 Rating plate
The rating plate with the performance data can be founded on the back of the device
4 Operation and Handing
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages.

4.1 Power Supply
Open the battery cover and insert four new batteries (1.5 V,
AAA). Use correct polarity
4.2 Replacing the battery
When the LCD display indicates low battery, open the battery
cover and replace the batteries with new ones.
Please note
►Old and new batteries should not be mixed.
4.3 Operation
4.3.1 Weighing
Put the food on the scale surface.
Press the key "TARE", the scale displays zero shortly after
"HELO" appeared in the display
Place the item to be weighed on the weighing surface and the
corresponding weight is displayed.
4.3.2 Tarafunction
Under the weight state, put the container on the scale surface,
LCD will show the weight of container.

Press the key of „TARE“, LCD shows zero and clears
the weight of container. Then put the food into the container,
the weight of food will appear on the display.
4.3.3 Turning off
Push the key "Tare" after weighing to turn off the device.After 1
min. Not in use, the device switches off by itself.
4.3.4 Unit Exchange
The system is under the state of weight, press „MODE“ to
select between „g“ and „oz“.
4.3.5 Over Load Indicator
When the scale is overloaded, „EEEE“ will appear on the
display. (min. weight 20 g / 0,7 oz, Max. weight 5.000 g.)
4.3.6 Over Load Indicator in Tarafuntion
When the scale is overloaded, in Tare-mode, “OUT2” will
appear on the display. Please replace the container with a
smaller one.
4.3.7 Unstable weight indicator:
When the scale is in the unstable state, the LCD will indicate
"Unst. Put the scale on a hard flat surface, it will work normally.

5 Troubleshooting
Please note
►If the balance is not working, check the batteries on your
performance, as well as for correct polarity. (Inserted the
right way).
6 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and
maintaining the device. Please observe the notices to prevent damages due to
cleaning the device incorrectly and to ensure trouble-free operation.
6.1 Safety information
Attention
Please observe the following safety notices, before you
commence with cleaning the device:
►The device must be cleaned and food residues must be
removed at regular intervals. If the scale is not maintained in
a clean condition, this will have a detrimental effect on the
service life of the device and can also result in a dangerous
condition in the device as well as in the growth of fungus and
bacteria.
►Never immerse the unit into water or the dishwasher.
►If dampness penetrates into the device, this can damage the
electronic components.
►Do not use any aggressive or abrasive cleaning agents or
solvents.
►Do not scrape off stubborn dirt with hard items.
6.2 Cleaning
Housing and display
Wipe the housing and the display with a damp cloth or sponge and mild dish soap.
6.3 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for their
functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they could
be detrimental to human health and the environment. Therefore, do not put your old
device into the non-recyclable waste under any circumstances.

Please note
►Utilise the collection point, established in your town, to return
and recycle old electric and electronic devices. If necessary,
contact your town hall, local refuse collection service or your
dealer for information.
►Ensure that your old device is stored safely away from
children until it is taken away.
7 Guarantee
12 Months Limited Warranty
Caso Design USA warrants that for a period of 12 months from the date of purchase, this
product will be free from defects in material and workmanship. Caso Design USA at its option,
will repair or replace this product or any component of the product found to be defective during
the warranty period. Replacement will be made with a new or remanufactured product or
component. If the product is no longer available, replacement may be made with a similar
product of equal or greater value. This is your exclusive warranty. DO NOT attempt to repair
or adjust any electrical or mechanical functions on this product. Doing so will void this
warranty.
This warranty is valid for the original retail purchaser from the date of the initial retail purchase
and is not transferable. Keep the original sales receipt. Proof of purchase is required to
obtain warranty performance.
This limited warranty does not cover normal wear of parts or damage resulting from any of the
following: negligent use or misuse of the product, use on improper voltage or current, use
contrary to the operating instructions, disassembly, repair or alteration by anyone other than
Caso Design USA service center. Further this limited warranty does not cover: Acts of God,
such as fire, flood, hurricanes and tornadoes.
What are the limits on Caso Design USA’s Liability?
Caso Design USA shall not be liable for any incidental or consequential damages caused by
the breach of any express, implied or statutory warranty or condition.
Except to the extent prohibited by applicable law, any implied warranty or condition of
merchantability or fitness for a particular purpose is limited in duration to the duration of the
above warranty.
Caso Design USA disclaims all other warranties, conditions, or representations, express
implied, statutory or otherwise.
Caso Design USA shall not be liable for any damages of any kind resulting from the purchase,
use or misuse of, or inability to use the product including incidental, special, consequential or

similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or
for any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of the incidental
or consequential damages or limitations on how long an implied warranty lasts, so the above
limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from
province to province, state to state, or jurisdiction to jurisdiction.
Table of contents
Other Caso Scale manuals