CASTLE V3M2 Mobile User manual

Getting started with your
Castles V3M2 Mobile

Thank you for ordering the Castles V3M2 Mobile
payment terminal.
In the box you will nd:
• Castles V3M2 3G terminal
• Charging deck
• 2x Till Rolls
• Micro USB and USB Plug Adaptor
• Installation guide
What’s in the box

Step 1
Connect the USB cable to power adaptor.
Step 2
Once the power supply is connected
to the power outlet, connect the
micro-USB to the terminal.
Step 3
Turn the power outlet ON and the
orange power light will come on showing
the terminal is charging.
Setting up your terminal

Step 1
Place the charging dock on a soft surface
with the back facing up.
Step 2
Lift the cable tidy.
Step 3
Connect the power cable into the DC 9V port
and the power supply to the power outlet. 
Step 4
The green power indicator will appear when
the charging dock is receiving power.
Step 5
Place the terminal onto the charging dock.
Step 6
If the terminal is receiving power
a solid orange light will appear.
Charging dock setup

Step 1
Pull upwards on the lever located
in the middle of the printer door.
Step 2
Place the till roll in the compartment.
The paper must feed from underneath
the roll.
Step 3
Close the printer door.
Install the till roll

Step 1
Press and hold the power button (above the
red key) until the screen lights up. The terminal
will power on and initialise for use.
Step 2
When the ‘enter amount’ screen is displayed,
attempt a test transaction with your own
payment card. An ‘approval’ message will
be displayed after a successful transaction.
How to take a payment