Cata EC60T2 User manual

Instruction Manual for the
Ceramic Hob
Model:EC60T2

High temperature protection
If excessive temperature is detected, the cooking plate will automatically
disconnect until a lower temperature is maintained
Safety
Dear customer,
Thank you for purchasing our ceramic hob.
Please read this instruction manual carefully before using and ensure it is
installed by a qualified electrician and to current UK regulations.
Care & Maintainence

2
Safety
2
3
Residual heat indicators
After using the hob, residual heat remains in the heating area. The
LED shows the code “H” which indictates that the zone is not safe to
touch
Auto shut down protection
During operation the hob will automatically shut off as detailed in
chart below
Installation
Selection of installation equipment
Drill holes on the work surface in accordance to the sizes shown below.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by
the heat radiation from the hotplate.
As shown in Figure (1)
Power level 1 2 3 4 5 6 7 8 9
Default working
time(hour) 8 8 8 4 4 4 2 2 2

Note: The safety distance between the ceramic hob and the cupboard
above the hotplate should be at least 750mm.
Air intake
Air exit
Figure (2)
mini 5 cm mini 5 mm
mini 2 cm
3
Under all circumstances, make sure the ceramic hob is well
ventilated and the air inlet and outlet are not blocked.
Ensure the ceramic hob is in a good work state. As shown in
Figure (2)
2
3 Place the hob on the table and screw the four brackets to the bottom of hob
(see picture) After installation adjust the bracket position to suit for
different table top thickness.
screw
bracket
base
screw hole

4
Please note
The ceramic hob must be installed by qualified personnel
or technicians in accoradance with current regulations. Please
never conduct the installation by yourself.
The ceramic hob should not be mounted above cooling equipment,
dishwashers and rotary dryers.
Please ensure there is adequate ventillation underneath the ceramic hob
to enhance its reliability
A steam cleaner is not to be used.
4.
1.
2.
3.
If the cable is damaged or to be replaced, the operation must be
carried out the by a qualified electrician with dedicated tools to avoid
any accidents.If the appliance is being connected directly to the
mains an omnipolar circuit-breaker must be installed with a
minimum opening of 3mm between contacts. The installer must
ensure that the correct electrical connection has been made and
The cable must not be bent or compressed.
The cable must be checked regularly and replaced by authorised
technicians only.
4
Figure (3)
Power line connection
that it complies with wiring diagram.
The installer must ensure that the correct electrical connection has
been made and that it complies with wiring diagram above.
The socket shall be connected according to the relevant standard
blue
green-yellow
N2 N1 L2 L1
grey
brown
black
220-240V
220-240V
blue
green-yellow
N L
grey
brown
black
220-240V
PE
PE
connect to the main power supply connect to the main power supply
220-240V 2+2N~ 220-240V 2+2N~
or connected to a single-pole cut-out. 30amp minimum supply.
The method of connection is shown in Figure (3):

The ceramic hob appearance
Schematic diagram of the control panel
Instructions for Use
5
Preparation before using
After power on, the buzzer bleeps once, all the indicators light up for 1 second
then go out, indicating the ceramic hob enters into standby mode.
Put the pan in the centre of the heating zone.
Childproof lock key
Power cord
ON/OFF
Glass plate
Control panel
ON/OFF
Power/Timer
regulating key
Timer

6
ON/OFF
Child safety
Note: 1. In standby working mode, touch the “ON/OFF” symbol
the heating zone will restore to the standby working
mode if there is no heat setting within 2 minutes.
2. Every heating zone is independent each other.
Childproof lock: To ensure the safety of children, the
hob is provided with the function of childproof lock.
Activating the childproof lock: When the lock is
deactivated, touch the “childproof lock” symbol to activate
the childproof lock. However when in the locked position,
the "stop" touch control has priority and cuts off the
power to the hob. The other buttons are disabled
except the “stop” touch control button and the “Lock”
button.
Deactivating the childproof lock: When the hob in is
locked mode, you can deactivate the childproof lock
by holding the “childproof lock” symbol.
The power of each heating zone are shown as follow:
Left rear Right rear
1200W 1800W 1800W
Left front
Right front
Heating zone
Power
Operation Instructions:
1200W
After the " ON/OFF "key is pressed,all the indicators show
" - ".Then you can set the heat setting of corresponding
heating zone
Timer function
Press the timer key, then the indicator flashes, and at this
point, you can set time. Using the “+" and “-“ keys, you
can set the timer from 1 to 99 minutes. When
the “+” key is pressed, the set time will increase by 1
minute;when the “-“ key is pressed, the set time will decrease
by 1 minute; when the set time exceeds 99 minutes,it will
restore to 0 minute automatically.
If press the "timer" key, the indicator displays 0.
Timer confirmation:
1.Select the power level of the cooking zone, then press
the "Timer" button, you can set the timer.
2. Once the timer indicator flashes for 5 seconds, the
set time will be confirmed automatically .
3. After selecting a set time, press the “Timer” key,
to confirm acceptance
.
Total power: see the nameplate

Keep electrical appliance out
of reach from children or
infirm person. Do not let them
use the appliances without
supervision.
Safety Reminder and Maintenance
After being used for a long
time, the corresponding
heating zone of the ceramic
cooker hob is still hot. Never
touch the ceramic surface to
avoid burning.
If the supply cord is damaged
, it must be replaced by the
manufacturer, its service agent
or similarly qualified persons
in order to avoid a hazard.
7
Never have the ceramic
cooker hob to work without
food inside, otherwise its
operational performance may
be affected.
A dedicated power protection
air swith protection air switch
must be incorporated in the
fixed wiring in accordance
with the wiring rules.
Never use the ceramic cooker
hob in high temperature
environments such as near a
gas stove or kerosene stove.
For sealed foods such as
canned goods, please do not
heat them before opening their
covers so as to avoid any
dangers of explosion due to
heating expansion.
If the surface is cracked, wipe
off the appliance to avoid the
possibility of electric shock.
Do not place rough or uneven
pans which may
damage the ceramic surface.
Do not put any detergents or
flammable materials in the
equipment installed under the
ceramic hob.
Do not leave metallic objects,
such as knives, forks, spoons
and lids on the hob as they may
get hot.

DISPOSAL: Do not dispose this
product as unsorted municipal
waste. Collection of such waste
separately for special treatment
is necessary.
8
Clean the ceramic hob
on a regular basis to prevent
the build up of food residue
Light Cleaning sponge
Burnt on stains
Specialist ceramic
cleaner
Rings and lime
residue
Aluminium
or plastics
Apply white vinegar to the
surface, then wipe it
dry with soft cloth
Use a scraper suitable for
ceramic glass to remove
residue
Specialist ceramic
cleaner
Specialist ceramic
cleaner
Care and Maintenance
You can easily clean the surface of the ceramic hob if
following the methods given in the table.
Caution: please disconnect power before the cleaning.
Type of contam-
ination Method of cleaning Articles used for
cleaning
Indoor use only.
clean with damp cloth and
dry it with another cloth
clean with damp cloth and
dry it with another cloth

Special DecIaration
All the contents in this material have been subjected to careful check.
For any mistake and omission in printing or misunderstanding of the
contents,the company keeps the right of interpretation.
Addition:any technical improvement will be placed in the revised
manual without notice;for product appearance and color is according
to the actual one
9
Your guarantee
For any failure of the product, please contact the
customer service centre.
1. There is a 2 year guarantee with this ceramic hob
2. The period of warranty shall start from the date on which the invoice
is issued.
3. Any one of the following cases is not covered by the guarantee:
Damage caused by improper use, storage and maintenance.
Damage caused by unauthorized disassembly and repair.
Valid receipt cannot be present.
Damage caused through mis-use.
Using the ceramic hob for commercial purposes.