Cavalier niagara 9096 User manual

Tails
Flange
Standpipe
4. Locate the assembly on the desired location with the flexible tails through the prepared hole and whilst holding
the flange, secure the standpipe.
NOTE: If mounting into wooden floor, secure standpipe using screws only (wall plugs are not required). If mounting
into solid floor, drill suitable sized holes for wall plugs first, then insert wall plugs in floor and finally secure the
standpipe using screws. Where required ensure correct plugs for your floor type are used.
5. Connect the flexi tails to water supply.
6. Check all new connections. Turn on water supply and allow to run for a few minutes to flush out the piping
system thoroughly. Check connections for watertightness.
Shower
handset
and hose
Spout
Diverter
Mixer
IMPORTANT
Please read these instructions carefully and
keep in a safe place for future reference. If you
are unsure of any part of the instructions in this
document then we recommend that you
contact a reputable qualified trades person.
INTRODUCTION
The Model supplied may vary from the image
shown below. Please note that the general
installation process for Freestanding Bath
Shower Taps are the same and the following
guide will take you through the process.
INSTALLATION
Please ensure you turn o mains water supply
before connecting to any existing pipe work.
Before installation identify all components and
inspect the product for any damage.
1. At desired location drill a hole in the floor
(min diameter: 57mm, max diameter: 65mm)
2. Place flange over the standpipe and then place
it to the base
3. Position flexi tails up through the standpipe
and then attach the flexi tails to the mixer.
Note: Do not reverse the hot and cold supply
Tails
Fixings
9096 Freestanding Bath
Shower Mixer Instruction
C20 V2
www.cavalierbathrooms.co.uk

SPOUT INSTALLATION
Place spout in top of the upright mixer, screw the collar into the top of the mixer by hand tightening only.
HAND SHOWER INSTALLATION
Insert a washer into each end of the shower hose and then screw it into the shower and mixer.
Note: Pull out the diverter to operate the hand shower
9096 Freestanding Bath
Shower Mixer Instruction
Guarantee
For full details of our guarantee please refer to our website. Our products are backed by a 10 year guarantee, this is
only valid to customers who complete and submit the online Niagara® Guarantee Registration Form within 30 days
of installation. Please note that products with finishes other than Chrome are guaranteed for 2 years only, these
products must also be registered online to activate the 2 Year Guarantee. To register and activate your guarantee
please visit www.niagarabathrooms.co.uk
Aftercare
Care MUST be taken when cleaning our products to avoid damaging the fitting or finish. To maintain the
appearance of the fitting, please ensure it is cleaned regularly using only a clean soft damp cloth. Whilst all
of our products are durable the finishes are vulnerable to some strong substances, we only recommend the
use of warm soapy water, DO NOT use abrasive sponges, strong household cleaners, scouring agents, organic
solvents or acidic cleaners as they may cause surface deterioration, peeling or change of colour.
C20 V2
www.cavalierbathrooms.co.uk