Cavalier niagara User manual

INSTALLATION
1) Before installation identify all components and inspect the product for any damage. Prior to installation, flush out
the pipework. Turn o the water supply before commencing installation.
2) Determine the fixing position and prepare recess for the faucet body. Make the recess in the wall according to
the dimension of the faucet body, the recess should be approximately 200mm x 49mm. The faucet body should
be fitted below the finished surface to allow the cover plate to fit correctly and flush against the wall. [ B ]
3) Position the faucet body in place and mark through the pre-drilled screw holes on the body, then drill the
marked points before inserting wall plugs into the wall holes. [ C ]
4) Connect the cold water inlet and hot water inlet correctly. If in any doubt please consult with a qualified trades
person.
5) Hold faucet body in place and secure to the wall with supplied fixings.
Figure DFigure CFigure B
Figure A
Faucet
body
Fixing Kit
Cover
plate
Spout
Lever
handle
hot inlet
cold
inlet
80mm
www.cavalierbathrooms.co.uk
C20 V2
Wall Mounted Basin
Mixer Instruction
IMPORTANT
Please read these instructions carefully and
keep in a safe place for future reference. If you
are unsure of any part of the instructions in
this document then we recommend that you
contact a reputable qualified trades person.
INTRODUCTION
The Model supplied may vary from the image
shown below. Please note that the general
installation process for all Wall Mounted taps
are the same and the following guide will take
you through the process.

6) Once the faucet body has been fitted correctly, ensure all connections are watertight.
7) Secure the cover plate onto the faucet body by applying clear silicone sealant around the back edge of the
cover plate and carefully pressing into position until it is flush with the wall/tiles. [ D ]
8) Fit the spout and handle in their correct positions as shown in diagram [ E ]. Hold the spout and handle in
position, screw and tighten until secure.
9) Finally, turn on water supply and allow to run for a few minutes to flush out the piping system thoroughly.
Figure E Figure F
Guarantee
For full details of our guarantee please refer to our website. Our products are backed by a 10 year guarantee, this is
only valid to customers who complete and submit the online Niagara® Guarantee Registration Form within 30 days
of installation. Please note that products with finishes other than Chrome are guaranteed for 2 years only, these
products must also be registered online to activate the 2 Year Guarantee. To register and activate your guarantee
please visit www.niagarabathrooms.co.uk
Aftercare
Care MUST be taken when cleaning our products to avoid damaging the fitting or finish. To maintain the
appearance of the fitting, please ensure it is cleaned regularly using only a clean soft damp cloth. Whilst all
of our products are durable the finishes are vulnerable to some strong substances, we only recommend the
use of warm soapy water, DO NOT use abrasive sponges, strong household cleaners, scouring agents, organic
solvents or acidic cleaners as they may cause surface deterioration, peeling or change of colour.
www.cavalierbathrooms.co.uk
C20 V2
Wall Mounted Basin
Mixer Instruction