CDM Sport BackSystem3 User manual

BackSystem3 Assembly Instructions
STEP 1: SEAT Place seat, cushion side down, on floor. Now place seat bracket
on top of seat and insert and tighten the four seat screws, with washers, with the
allen wrench provided. Attach the seat with the small end of the seat toward the
front upright, with the wide end toward the back of the machine. (as shown)
1
4
3
2
STEP 2: HANDLEBARS Hold the handlebar horizontal and place the bolt through the top bracket hole. STEP 3: Once you have
the bolt through both the bracket and the handlebar, flip the handlebar up and put the other bolt through. STEP 4: When you
tighten this bolt, stand in front of the machine, leaning against the handlebar so that you have pressure toward the back of the ma-
chine. ( as shown) Tighten the bottom bolt first, STEP 5: followed by the top bolt.
5
* Make sure the handlebar is
tightened firmly so that the
handlebar does not move when
using the machine to rotate
back.
6
STEP 6: FOOT PEDAL AND AXLE
You should receive your BackSystem3™ with foot pedals on the axle as follows;
Collar (tightened by allen set screw) rubber o-ring, pedal, rubber o-ring. Repeat on
the other side. Before placing seat & roller unit into the base, make sure you have
unscrewed the allen screws enough, allowing the axle to slide freely through the
holes.

7
8
9
10
11
12
NOTE 7: For the Pro Model only
(
black unit for people over 6’1”)
Place the two black spacers next to the bracket and the pedal o-rings
will be on the outside of each of those spacers. The spacers are not to be
used on the standard unit.
STEP 8: SEAT POST When you place the long axle through the
upright, if you are right handed, put it in on the left side of the ma-
chine, standing behind the machine. DO NOT USE A HAMMER!
USE A RUBBER MALLET. Slide or shove the axle through. Place
another 0-ring, pedal, o-ring and finally the collar.
STEP 9: Put the allen wrench in the collar and apply pres-
sure, squeezing together both sides, tightening with your
thumb, maintaining pressure until secure. Left handed peo-
ple will want to do this assembly in the opposite direction.
NOTE 9: Once you have the axle and the collars tightened, the
pedals should not turn freely. Make sure the lip on the top of the
pedal is toward the back of unit when top of the pedal is up.
(Your heel should fit into the curved part.)
STEP 10: Tighten down the allens onto the axle, which will prevent the pedals from rotat-
ing as you use the machine. Make sure they are unscrewed before attempting to slide the
axle into the bracket and upright.
STEP 11: Install the wire holder for the stretch
guide (found in a separate box within the big box).
Loosen the 3 allen screws, slide the holder into the
cylinder and tighten the screws so that the holder is
angled.
BackSystems, Inc. ©2000
For Questions call:
800-538-4811
YOU MUST USE SAFETY STRAPS!
STEP 12: Shows the placement of the safety straps and stretch guide .
There is a single loop on the end of each strap which fits onto each side of the handle-
bar and rests next to the upright.