cef KIDS HATT User manual

Assembly Instructions
HATT-Height Adjustable Tilt Table
KIDS
Our Customers. Our Inspiration.
We should all try to be more like them

Components
What’s in the Box!
•LEGS (2)
•TABLE TOP
•FEET (2)
•SUPPORT BEAM
•#12 PHILLIPS PAN HEAD SCREW (8)
•5MM HEX SCREW (2)
•6MM HEX SCREW (8)

LEGS SUPPORT BEAM FEET
TABLE TOP
#12 PHILLIPS PAN HEAD SCREWS 5MM HEX SCREWS 6MM HEX SCREWS
•Metric Allen Wrench/Hex Key 5mm
•Metric Allen Wrench/Hex Key 6mm
•Drill/Driver w/ Phillips Head Bit
TOOLS NEEDED:

Let’s Get Started!
CAREFULLY REMOVE THE HATT TILT TABLE
TOP OUT OF THE BOX AND PLACE FACE
DOWN ON A SMOOTH SURFACE TO PROTECT
THE DRY ERASE SURFACE
REMOVE LEG (A) FROM ITS INDIVIDUAL BOX
AND PLACE IT ON TOP OF THE BASE LABELED (A)

TIGHTEN THE SCREWS USING A DRILL OR DRIVER
WITH A PHILLIPS HEAD BIT
TAKE FOUR #12 PHILLIPS PAN HEAD SCREWS
AND INSERT THEM INTO THE FOUR HOLES IN LEG
(A) AND INTO BASE (A)
REMOVE THE SUPPORT BEAM FROM ITS
INDIVUAL BOX AND SLIDE THE SUPPORT BEAM
OVER THE BRACKET ON LEG (A)

WHILE HOLDING THE FREE END OF THE SUPPORT
BEAM, PLACE LEG (B) DOWN ON TOP OF BASE
(B), SIMULTANEOUSLY SLIDING THE SUPPORT
BEAM OVER THE BRACKET ON LEG (B)
SECURE THE SUPPORT BEAM TO THE BRACKET
USING A 5MM HEX SCREW AND ALLEN WRENCH
** DO NOT OVERTIGHTEN THE SCREW

TAKE FOUR #12 PHILLIPS PAN HEAD
SCREWS AND INSERT THEM THROUGH
THE FOUR HOLES IN LEG (B) AND INTO
BASE (B)
TIGHTEN THE SCREWS USING A DRILL OR DRIVER
AND A PHILLIPS HEAD BIT

SECURE THE SUPPORT BEAM TO THE
BRACKET ON LEG (B) USING A 5MM HEX
SCREW AND ALLEN WRENCH
** DO NOT OVERTIGHTEN THE SCREW
ATTACH ONE FOOT ASSEMBLY TO LEG
(A)
AND ONE TO LEG (B)
SECURE THE FOOT ASSEMBLIES TO THE
LEGS USING EIGHT 6MM HEX SCREWS
AND AN ALLEN WRENCH

YOUR TABLE IS NOW COMPLETE! ABOVE IS A
PICTURE OF THE HEIGHT ADJUSTABLE TILT
TABLE FULLY ASSEMBLED
USE CAUTION AND WITH ASSISTANCE FLIP THE
TABLE OVER AND YOU ARE READY TO USE YOUR
NEW PRODUCT!
***WARNING**
DO NOT SIT ON TABLE!
TABLE IS NOT DESIGNED TO SUPPORT
EDGE WEIGHT INTRODUCED BY SITTING,
REGARDLESS OF WEIGHT.