Celebrity Massage Recliner User manual

How to assemble and get
the best out of your new
Massage ecliner
Made in the UK
Massage Recliner
User Guide

Thanks
for choosing
Celebrity
Thank you for choosing a Celebrity
Massage System, which we hope will
give you many years of comfort and
enjoyment.
Your new Massage System offers you the latest
in massage technology – all at the touch of a
button. Now you can experience the benefits of
a vibrating massage or a soothing back heat, in
the comfort of your chair.
To get maximum benefits from the system, please
spend a few minutes reading the following
instructions. By fully understanding the method
of operation of the system, you will be able to
gain maximum benefit from it.
These instructions should be read in conjunction
with our Operating and Care Instruction leaflet,
which is attached to your chair. Should no copy
of the Operating and Care Instructions be
attached to this chair, please contact our
Customer Services Department on
01623 440 626 or email us at
[email protected]
2
Important
This unit is intended for relaxation purposes
only and should not be used in an attempt to
treat any medical ailment.
Please note that should you have any medical
condition, be under a health professional or
physicians care or should you have a medical
device fitted (eg Pacemaker etc.) you must
consult a qualified medical practitioner, before
using this massage system.
lDo not massage any part of the
body that is painful, swollen, inflamed
or covered with skin irritation – consult
your medical practitioner before use.
lThe massage system should not be
used during pregnancy.
lDo not at any time allow children
to play on the chair or leave them
unsupervised, in the same room as
the chair.
lNever operate this appliance if it has a
damaged cord or plug. Contact your
supplying retailer.
lDo not interfere with any part of the
massage system or attempt to dismantle
or repair the unit in any way.

Assembly and connections
Made in the UK
3
Your chair is supplied with the base and the back as separate
units. To assemble the chair hold the back and fabric flap
with both hands. ine up the male and female brackets on
the base and back. Apply downward force to the back and
the connectors will fit into one another.
Then connect the massage leads as follows:
Lea 1 - Heat Pa (White connector)
Connect the lead (A) from the back of the chair to the
corresponding lead in the base.
Lea 2 – Motor (Blue ring on connector)
Connect the lead (B) from the back of the chair to the
corresponding lead in the base.
Lea 3 – Power (Red ring on connector)
Connect the lead (C) to the transformer unit supplied
with the chair. Next connect the plug lead to the transformer and
plug in to the power socket.
Your massage system is now ready for use when the power
is switched on.
By following these step by step
assembly instructions your new
massage recliner will be ready
to use.
Connections from back of chair
Connections from base of chair
ABC
A
B
C
Heat Pa Connection
Massage Motor Connection
Transformer Connection
AB

Helpful Information
First Use
We recommend that the unit be used only for a
few minutes initially, to allow your body to get
used to the massage sensation. Gradually
increase the length of time you use the massage
function, over the first few periods of use. Should
you experience any adverse reactions, stop using
immediately and consult your medical practitioner.
Personal Use Only
The unit is designed and guaranteed for personal,
home use only.
Do not use for any commercial purpose, as this
will invalidate the guarantee.
General Information
NOISE: As with any motorised system which uses
vibration to activate the motion, there will be an
amount of noise and vibration. This is particularly
prevalent around the upper back area, where the
ears are more sensitive to any noise and vibration
from the motors situated in the back of the chair.
Additionally, noise may be emitted from the
footrest, when no leg pressure is applied and the
footrest is in the closed position. This is due to the
fact that for safety reasons (to reduce the risk of
possible damage from entrapment between
footrest and chair) the reclining mechanism
situated under the chair, features a sprung-loaded
footrest. The springs in the footrest may transmit
a vibration noise, until the weight of the legs
reduces the amount of vibration transmitted to the
springs. Further vibration may be caused by some
of the metal action mechanism parts
vibrating against each other and causing a noise.
Service
Never attempt to repair or service this unit yourself.
Should you have any service requirements, always
contact your supplying retailer, in the first instance.
Guarantee
Your Massage System is fully guaranteed for 12
months from the date of purchase, providing that
it has been used in accordance with our Operating
Instructions.
This guarantee covers any failure of the system
due to manufacturing defects within this period,
providing the chair has been used for domestic use
only. Any use of the chair for commercial purposes
invalidates the guarantee.
Please note that this guarantee does not cover any
instances of misuse of or damage to the chair.
4

Made in the UK
Your Chair Explained
The picture below shows all 5-massage zones, plus the heat pad
that is contained in your massage chair.
The section on pages 6 and 7 explains how your handset will
give you the best results from your massage system.
Please Note:
Zone 1: Upper Back
Zone 2: ower Back
Heat Pad
Zone 3: Upper Thigh
Zone 4:
ower Thigh
Zone 5:
Calf Region
Please note that anyone with a me ical
evice (e.g. pacemaker) or me ical con ition
must consult with their octor/healthcare
professional before purchasing a massage system.
5

Your Massage Handset Explained
1: Power
This button switches the massage system
on or off. Depress the button to switch on
(please note that the handset buttons will
illuminate and the display will confirm that
the massage system is active). To switch off,
depress the button again.
The massage system is programmed to
allow 15 minutes of continual use, before
automatically switching itself off.
Please note, when left inactive, the LCD
illumination will switch off after 30
seconds, but will leave the functional
buttons selected illuminated, until the
system automatically switches itself off
after 15 minutes.
When the massage system is switched off,
the handset retains the last settings in its
memory. When switched back on, the
massage will automatically start with the
last used settings.
Please note: the power button is designed
to illuminate at all times (even when the
rest of the handset is not illuminated) to
show that the massage system has been
successfully connected to the power supply.
To get the best results from your Massage System, it is essential
that you first understand the functions of the handset. Please take
a little time to fully ac uaint yourself with these functions and
then adjust the speed and intensity of the massage, to suit your
own re uirements.
2: Zone
Selection
Control
1: Power
3: Pre
Programmed
Functions
4: Intensity
5: Speed
6: Heat
6

Zone Selection Control
Please follow the steps below to get the best
results from your massage system.
2. Zone Selection Control
To choose the zones you wish to operate, simply press
the appropriate zone selection buttons from 1 to 5.
Each button offers individual control of the selected
zone, from top of the back (1) to the calves (5). As
each button is selected, the zone button will glow and
the display will confirm active zones. (Blue zones on
LCD indicate active zone).
3. Pre-Programmed Functions
Your massage system is equipped with 3
pre-programmed functions for your enjoyment:
Wave: Offers complete head to toe massage by
operating each selected zone in turn, starting at
the top back (zone 1) and working through to the
calves (5).
This programme can be operated at any level of
intensity and at any speed (see sections 4 & 5). You can
select/de-select any zone by pressing the zone button
(see section 2). Pressing the Wave button will return
the system to the Manual zone select option.
Tap: On activation all selected zones are operated
together in short bursts. Tap can be used on any
combination of zones, or on all 5 zones at once. This
programme can also be adjusted to operate at any
level of intensity and at any speed (see sections 4 & 5).
You can also select/de-select any zone by pressing the
zone button (see section 2). Pressing the Tap button
will return the system to the Manual zone select
option.
Swell: This function offers a rolling massage to each
zone sequentially, vibrating from minimum to
maximum selected intensity. Swell can be used on any
combination of zones, or on all 5 zones at once. Swell
can also be adjusted to operate at any level of intensity
and at any speed (see sections 4 & 5). You can also
select/de-select a zone by pressing the zone button
(see section 2). Pressing the Swell button will return
the system to the Manual zone select option.
4.Intensity
The system offers varying levels of intensity, from a
gentle massage, at the lowest level, to a more vigorous
effect at maximum intensity. Press the intensity + or –
button to increase or decrease the intensity. The LCD
display will confirm the intensity level selected.
5. Speed
The speed selector only works when the Wave, Tap
or Swell pre-programmed functions are selected. The
speed selection offers varying speeds from slow to fast.
Press the intensity + or – button to increase or decrease
the intensity. The LCD display will confirm the intensity
level selected.
6. Heat - & +
The Heat buttons operate differently to the
Intensity & Speed buttons in that they only switch
the Heat Pad on (+) or off (-). You cannot increase
or decrease the operating temperature of the heat
pad with these buttons.
Once activated a red heat symbol appears in the
LCD. This will extinguish along with the LCD
display after 15 seconds but the heat pad will
remain fully operational.
The heat pad is fitted with a pre-set thermostat,
which, once the pad attains its operating temperature,
cycles on and off to maintain the pre-set level of
heat. The pad automatically switches off after 15
minutes use.
7

This Massage ecliner
User Guide should be read
in conjunction with
Celebrity’s recliner
Operating and Care
Instructions booklet and
should be kept for future
reference.
www.celebrity-furniture.co.uk
Made in the UK
Celebrity Motion Furniture Limite .
Common Road, Huthwaite, Notts. NG17 2JY. Tel No: 01623 440 626 / Fax No: 01623 444 889