20mm
12mm
14mm
12mm
AB08 TRI EXTENSION
MOUNT ASSEMBLY
Extension Mount Upper
Right
Extension Mount
Base Right
Handlebar
Mounting Screws
M5 x 0.8 x 14 FHCS TX
Qty:4
EX11 Arm Pad Carrier
Right
EX11 Arm Pad
Right
HBP-AB08-EXTMT
Extension Mount
Upper
Left
EX11 Arm Pad
Carrier
Left
EX11 Arm Pad
Left
Upper to Base
Mounting Screws
M5x0.8x20 SHCS LP
Qty:4
Pad Mounting
Screws
M5x0.8x12 BHCS LT
Qty:4
Extension
Clamping Screws
M4x0.7x12 SHCS LP
Qty:4
ADJUSTING THE PAD POSITION
Extension mount base
parts are clearly labelled
for proper installation.
Mixing these parts will
void warranty and may
result in injury.
If extension shifters are used,
route E-wire through the back of
the extension and into the slot
on the back of the mount base.
Ensure that the extensions end at
the minimum cut line.
E-WIRE ROUTING
Tuck cable into rear
slot on mount base.
Tuck cable
into slot on
mount upper.
“R” indicates right
side, and arrow
should point forward
Use the Pad Mounting Screws to
adjust position of the Arm Pad
Carriers.
Once desired angle is found, torque
the bolts to 3Nm.
The fixing screws must be installed
in fore-aft fixing position, and not
diagonal.
ADJUSTING THE TILT
15°
Use the Upper Mounting
bolts to adjust the tilt of the
extension and pads
anywhere from 0-15 degrees.
Once desired angle is found,
torque the bolts to 3Nm.
Upper Mounting
Bolts
0°
Note: Bar and
Stem not included
in assembly
This product cannot be used in conjunction with the
Handlebar Pitch Adjust Spacers. Doing so will void
warranty and may result in injury.
Pad Mounting
Screws
Narrow Setting
Wide
Setting
Secure the extensions by
tightening Extenstion
Clamping bolts to 3Nm.
If cutting the extensions,
ensure that there is NO MORE
THAN 5MM inside the rear edge
of the mount upper.
EXTENSION POSITIONING Minimum
Cut
Line
Extension
Clamping
Bolts
5MM
Extension Mount
Base
Left
AB08_TRI_Guide_V1.5 20190527
