Chamberlain Kinetic Trolley User manual

Liftmaster Materials handling
ABN 74 005 237 525
www.liftmastermh.com.au
Kinetic Trolley – Operating Instructions:
Please Note: do not open or tamper with the electrics under the top deck, as this will void all warranty and or may
cause serious injury to operators of the unit.
1) Check from the power indicatorthat the unit has sufficient charge and turn the unit on by pressing the red
power button located on the side of the steering shaft located on the right hand side of the battery
indicator.
To Operate the Unit:
2) To engage power supply, lower the handle so that it is almost in line with your waist, you should just be able
to see the top of the handle console.
Forward / Reverse Operation:
3) To go backwards (tow) use your thumb to press the toggle down and to go forwards (push) use your thumb
to press the toggle up.
Reverse
(press down)
Forwards
(press up)

HEAD OFFICE & FACTORY
[phone]
[phone]
[e-mail]
PO Box 125
Sunshine, VIC, 3020
NEW SOUTH WALES
1/14 Holbeche Rd
Arndell park NSW 2148
[e-mail]
Ph: 02 9621 7594
Fax: [phone]
QUEENSLAND
453 Newman Rd
Geebung QLD
[e-mail]
Ph: 07 3865 2756
Fax: [phone]
www.liftmastermh.com.au
Liftmaster Materials handling
ABN 74 005 237 525
www.liftmastermh.com.au
Steering the Kinetic Trolley:
1) To steer, either pull the handle from left or right.
Buttons and Switches:
2) F.1 Showsthe horn button located just above the red safetybutton forattracting attention. F2. shows the
FAST/SLOW speed switch to adjust the power of the unit to suit your environment and towing needs.
F1. F2.
Emergency Stop:
3) For emergency stoppress the big red safety button (See F3.). The switch is designed to engage if the
operator makes firm contact with the unit whilst towing. Note: the black pads are not buttons (see F4.)
F3. F4.

HEAD OFFICE & FACTORY
[phone]
[phone]
[e-mail]
PO Box 125
Sunshine, VIC, 3020
NEW SOUTH WALES
1/14 Holbeche Rd
Arndell park NSW 2148
[e-mail]
Ph: 02 9621 7594
Fax: [phone]
QUEENSLAND
453 Newman Rd
Geebung QLD
[e-mail]
Ph: 07 3865 2756
Fax: [phone]
www.liftmastermh.com.au
Liftmaster Materials handling
ABN 74 005 237 525
www.liftmastermh.com.au
Faults:
Should you encounter any major concerns with your Kinetic Trolley please ensure you check the following items first:
1. Loss of drive - Ensure the battery is fully charged and or the Tiller handle has been placed back in the upright
position which resets the unit.
From this try operating the unit and should this be succesful continue operation.
If not please contact your nearest Liftmaster Material Handling representative office for assistance.