Champion S2U User manual

P.O. Box 845, Alpharetta, GA 30009 5936-A Peachtree Rd, Atlanta, GA 30341
Phone [phone] Fax [phone]
How to remove your S2U Computer
Tools Required
Metric Allen Set
#1Phillips Extended Screwdriver
#2 Phillips Screwdriver
Cutters
Vacuum Cleaner
1) Make sure the bike is unplugged from the wall outlet. Remove the hardware
holding the conduit tube at the top of the computer and the bolts that hold
the computer to the frame of the bike. There are four and they will have red
262 loctite. TAKE CARE WHEN REMOVING THESE BOLTS. DO NOT STRIP
OUT. (FIG 1)

P.O. Box 845, Alpharetta, GA 30009 5936-A Peachtree Rd, Atlanta, GA 30341
Phone [phone] Fax [phone]
2) WITH EXTREME CAUTION , gently and carefully slide the computer forward
away from the bike. You may need to lift up slightly on the bike to clear the
conduit tube. (Fig 2)
3) Use the #1 Phillips to remove the tiny hidden screws around the perimeter of the
housing. Use the #2 Phillips to remove the 3 center screws on each side. (Fig 3)

P.O. Box 845, Alpharetta, GA 30009 5936-A Peachtree Rd, Atlanta, GA 30341
Phone [phone] Fax [phone]
4) The two halves of the case can now be separated. Use the vacuum to remove any
dust bunnies you find. (Fig 4)
5) In the next step you will disconnect the cables that connect the computer to the
bike. WE STRONGLY RECOMMEND TAKING PHOTOS AT THIS STEP BEFORE
DISCONNECTING ANY CONNECTOR. This will make reconnecting your computer
easier. There are connections on the front and rear of the computer. You may need
to cut (USE EXTREME CAUTION) any wire ties to release the cables. (Fig 5 & 6)
6) Your computer should now be free of the bike and can be packaged and sent in for
repair. To reinstall the computer, simply reverse the above steps.