Channel Vision C-0310 User manual

© 01/99, CHANNEL VISION™
ChannelVision
LimitedWarranty
Channel Vision Technology will repair or replace any defect
in material or workmanship which occur during normal use
of this product with new or rebuilt parts, free of charge in
the USA, for one year from the date of original purchase.
This warranty does not cover damages in shipment, failures
caused by other products not supplied by Channel Vision
Technology, or failures due to accident, misuse, abuse, or
alteration of the equipment. This warranty extends only to
the original purchaser. A purchase receipt, invoice, or other
proof of original purchase date will be required before
warranty repairs are provided.
Mail in service can be obtained during the warranty period
by calling toll free [phone]. A Return Authorization
number must be obtained in advance and be marked on the
outside of the shipping carton.
This warranty gives you specific legal rights, and you may
have other rights which vary from state to state. If a
problem with this product develops during or after the
warranty period, please contact Channel Vision, your dealer,
or any factory-authorized service center.
C-0310
10dB RF Amplifier
234 FISCHER AVENUE lCOSTA MESA, CA 92626
[phone] l(800) 840-0288 l(714) 424-6510 FAX
Central

Description
Channel Vision’s 10dB power injected amplifier increases the strength of the
incoming cable or antenna signal. The increased signal strength means that you
can distribute the television signal longer distances and to more outputs.
Unlike most RF amplifiers, the C-0310 uses an external power supply that can
be connected directly to the unit using a coax “F” connector. For added
versatility an optional power injector may be used to feed power back to the
amplifier from a remote location, thereby eliminating the need to install the C-
0310 near a power outlet.
Instructions
Step 1: Snap the C-0310 into C-0112,C-0119,C-0138,C-0150 chassis of your
choice.
Step 2: Connect the incoming cable or antenna line to the INPUT port.
Step 3: Connect the outgoing coax cable to the OUTPUT port to distribute the
signal to all the TV’s in the house.
Step 4: Connect the power transformer to the DC12V INPUT. You can use an
optional power injector (model #CVT-PI) down line in the system. If using
a power injector, you must use DC passive splitters and DC blockers in the
system (please see diagram).
Please Note:
The unused trunk line connector of the last outlet device in each trunk line MUST
BE TERMINATED using a 75Ωterminator (model 2101).
Standard Wiring Layout Layout with Power Injector
IN OUT
Channel Vision
C-0310
DC12V
INPUT
Cable or
Antenna
IN OUT
Channel Vision
C-0310
DC12V
INPUT
Cable or
Antenna
HS-3
CVT-PI
880
DC Blocker
Warning
To prevent fire or shock hazard, do not
expose this appliance to rain or moisture
Specifications
Bandwidth 45-1000Mhz
Gain 10dB +/-1.5
Flatness +/-1dB
Return Loss (min) 14dB
Output Power +10dB
Dist. X-Mod. -70dB
CTB -65dB
Power Supply 12V/55mA