Chef WM-639SS-30 User manual

9
10

1 2

WM-639SS-30: 29.75" W
WM-639SS-36: 35.25" W
18.75" D
20.5" -38.25" H
3 4
2
Mounting screws
WM639SS-36:895mm(35.25")
DD
EE
Duct cover
Attach bracket to duct cover 2
EE
DD
6
Gasket for outlet adapter mounting & duct cover bracket screws
4
4
Outlet adapter mounting screws

NON-DUCTED MODE
5 6
2. Please open the carton box and make sure
the foam under the wind wheel is take off
before install
Foam board
4.Mark the wall by following the mounng
hole to center the range hood. Drill the 2
mounng screws (AA) into the wall.
4.Mark the wall by following the mounng
hole to center the range hood. Drill the 2
mounng screws (AA) into the wall.
6. Aach and secure vent pipe to the adapter. Use
aluminum tape and wrap around the connecon
to make it air ght. Please note,to reduce the risk
of fire use metal ductwork.(Metal duct should be
purchased separately)
1. Carefully mark the range hood placement
on the wall.Range hood should be placed at
a distance of 24'' to 30'' or recommended by
local building code.
21mm
Holes on wall
5.Mount the range hood to the two mounng
screws that were installed in Step 4.
3.Aached the 6in. round adapter to the
outletand secure it using four screws
(BB) with gaskets (CC).
7. Aach the bracket to the inner duct cover and
secure by 2 screws (EE) onthe side. Carefully
insert both duct cover into the range hood.
8. Adjust to the desirable height by raising the
innerduct cover and secure the posion with
the bracket installed in Step 7 using the two
screws (DD) provided.
Recirculaon Mode
Cauon:Do not use plasc or rigid metal ducng.
1. Install the charcoal filter on.
2. Please note that the air will flow out from the
two grids on the two sides of the chimney top.

Press to power on and off.
Press once to reduce fan speed.
Press once to increase fan speed.
Press once to turn on the lamp. Press again to turn it off.
Press to acve the delay shut-off funcon. To set the duraon, press and
hold the buon for 3 second unl power buon blinks. Set the duraon
between 1 minute to 9 minutes by pressing "+" or "-". Once select the
desired duraon, press the buon again to set the duraon.
7 8
1. Disengage the baffle filter from the hood by pull the lever and slowly take the filter down.
2. Clean the filters with a warm detergent solution carefully without bending and then set to dry before putting it back.
3. Reinstall the baffle filters.

9 10